Search results

Support the engine and undo the motor mounts. Remove abs sensors and brake lines. Then remove subframe. If you have access to a lift itshould take about an hour and a half.

Getting machine work is like getting your hair cut. If you dont explicitly tell them what you want dont be disapointed by the results. Your instructions with that gasket will have the RA requirements. Go back there and tell them to do it right or stay away and take it to someone that can.

Driftmotion has new one for like $45

Your not using a MHG right? That surface finish does not look good enough to seal one...

Wet down. 10% simple green for 15 min. Pressure washed at ~150F.

We need an internet bill of rights. !

Check out this guy..

Anyone know which ecu pin goes to the front or back knock sensor?

Ready to drop in! need to figure out the throttle linkage and get the lower half of the dipstick. The size of the walmart filter scares me...

IJ was right! Tons of crap in the crank!

My arp studs were 82ft/ibs w/ lube. That's what I thought cause you don't have to torque it in degrees.

I thought you could reuse stock main and rod bolts?::hang::

I've been in the RC hobby for about 6 years, unfortunately the supra has taken away all of my attention. :(. I've had trucks, boats, planes, helis, and even a uav. Most addictive hobby I've ever had. My camera plane... http://www.youtube.com/watch?v=sNcVSmu0i3s

I sandblasted and used BBQ paint.

I don't think turning up the line pressure is nessasary. The throttle cable does it for you.

Found it. 57mm.

I bought a coupler for the throttle body and its too long. If someone could check to see how long their stock one is that would be awesome. Thanks.

Anyone with custom throttle cables?

Why did you buy the pistons before you had the block checked out?

I have the sony gogle tv bluray player. Its pretty cool. Can wait for the app store to be released.