Search results

What computer are you using? I assume a 2JZ computer. It is most likely your map sensor, trace all the wiring back to the computer and make sure nothing is shorting out. Any codes?

You mean the spring loaded ones that keep the shifter socket straight?

Mods please? :) It says built motor. What did you do to it?

I assembled my snap ring setup wrong on the pressure plate and that caused the hub to spin with the pressure plate, which made it vibrate and hit the clutch fork and the the clutch pedal would vibrate when it was pressed.

Which bolts? The tower bolts or on the case?

Shoots but atleast it doesnt look like any frame damage.

Popping out of gear.... 1) You have bad synchros. 2) Parts were incorrectly installed. 3) Improperly installed locking balls(detents). 4) Bad Hubs You said you have it rebuilt, so I doubt number one is the cause. I contacted Joliroger about a problem I had since he rebuilt many R154s and he...

You can get the new hardware from Toyota. Just soak it overnight and see what happens. If that doesn't work, try heating it and using an impact. If that doesn't work, then cut it off.

Pictures?

You don't need a line to drain it. That would be just like venting it to the atmosphere. A 1/8NPT bung with a block off is good enough. You should not have a full catch can. You can drain it every couple oil changes. Our cans can have a see through portion to show it's level if the customer...

......:nono:

Less rotating parts, less parts to break right? Maybe that's why it is so durable?

No, I doubt he would swap the wheels out. There is a lot involved in taking it apart, would have been simpler to just change the turbo.

He plays Modern Warfare? I didn't know that. I am going to send him an invite.

That transmission looks simpler than most I have seen open!

Maybe the hose that goes over the wastegate melted and got oil over the exhaust? Would it burn off though, unless it was a lot, then it would catch a fire. I am not to sure on this though. I know the 7M has the alternator up top where I have seen the hot wire short out on the hood and cause...

Catch Cans? I can help. Visit my link in my signature. :) You must use vacuum to work properly.

It all depends on the power level you want. Don't get something that will be overkill but just enough head room.

Just a thought, is that line submersible in fuel? I have seen fuel hose crack when submerged in-tank.

I suggest six puck clutch. I have a stock clutch and on my 1JZ, even with the upgrades but just stock fuel, at 9LBS, it slips when just getting into boost. It gave me a few pulls, four at the most and it gave up.