Search results

Bishop: Good idea. Nick: I figured that was where you were going but have not tried it myself. This is interesting... Does it do it when the hood is fully closed or as soon as you release the latch inside the car or only when you open the hood outside?

I think if it is 2 wires to the motor only, then apply power to red and ground to green. If it goes down instead of up, then reverse the power to green and ground to the red wire to get it to go up... http://www.cygnusx1.net/supra/library/TSRM/be/BE_050.html

I think Nick is on to something.. Check to see if your fan clutch is locked up. It should only be locked up when it is up to temp and the thermostat opens.

:drink1:

Nice run Besttrans... :)

This thread went from sad to bad in 60ft. I blame Neal H. Moritz directly..:3d_frown:

Does the N/A distributor send the RPM signal to the ECU or do they have a crank sensor. Does your tachometer work? What ever it is? Code 12 is a loss of rpm signal to the ECU.. Edit: It looks like the RPM pickup is installed inside the distributor on N/A's, so check those smaller wire...

My TCCS says code 12 is usually a poor CPS connection in G or NE signal wires to the ECU.. I would think these poor connections could also effect timing but this is just my guess.

All you need is a paper clip to check your codes. Here are the detailed instructions on how to check codes and the definitions of the codes.... http://www.cygnusx1.net/supra/techtip/engineerrorcodes.html

The 18th or the 25th?

Ok, just checking.. :)

Alaska? Canada? Denver? I even have a friend here in Washington who has a permit for it. Here is an herb map... http://www.norml.org/index.cfm?Group_ID=4516

Is that from the set of "water world" Ian? LMAO Is it FEMA's fault the truck drivers parked them so close together that no one can get to the front or back doors.. ;)

I drive mine daily for fun.. I get 21-25mpg after mods. "mileage"

Have you checked your codes yet?

You guys are correct.. I just double checked and I bought a 3" and it is still sitting on my shelf because it was too big and I had to buy another 2.75 inch coupler.

I want to say 3" but it has been so long since I changed it that I am not 100% sure.. Free bump...

Cheating?? ;) LMAO You said they were on your site, so I searched your site from your link in your sig and found one with the "comic" label under the link... LOL yes I cheat...:icon_razz