Search results

It pulled strong, does it already have some mods done to it?

True, true!

Most of the chinaman manifolds need some modification done to the external wastegate flanges, they will not fit if you don't cut and reweld them.

Bigger injectors aren't needed if the car is tuned right, but this one isn't ;).

Don't cap off your bypass valve. If you think it has a boost leak, then check for it, but you're not throwing codes right? Do you still have the original cats on it?

Hell, just by the looks of it I though they threw the head or the intake manifold through the hatch ;). if it's around $400 then it's probably a decent deal.

Got any specs on the new one you plan on getting?

Got any quarter mile times?

God Damn, do you guys know how to search? This is a subject that is brought up every freaking day, nothing's changed on the answers to these questions you guys are asking on this subject (and everyone of these has been asked TONS of time already within the past few months) :3d_frown:.

You should look on their website at what china's churning out for copies now... It's getting damn hard to tell the difference between the real deal and a fake. Hell, even the fakes are cast with the Tial logo!

True. Dust in the motor = dust in the oil = premature wear on bearings. Foreign object = FUBAR ;).

Yup ;). http://summitracing.com/

Think of the A/F's, if it's open at idle/part throttle, then the AFM isn't seeing that extra air comming in, so it's leaning out...

Sounds like it's not meant for a car using an air metering system. :icon_conf

Looks like they make a nice piece to be used as a stock replacement. Doesn't say how much psi it can handle, but I bet it's up to par (most likely better) than any of the bosc replacements. And they are 88.50 pounds, so, what? 160.00 usd?

ANY metal head gasket must have a flat, smooth surface for BOTH mating areas (head and block) They must also be smooth enough to seal, most manufactures don't go any lower than an RA spec of 20, so 15 is playing it safe. The smoother the surface the better the seal when it comes to a MHG.

I did a quick search too and didn't come up with any hits on that name.

They do look to be better than the average ebay IC, but they are just too darn big for most of us, bigger isn't always better ;). For my particular setup, I'll be flowing close to 800 CFM's at 6500 RPM's. That's at 20 psi using 2.5" piping on everthying, including TB. The spearco replicas and...

If it's staying open, but closes only when you are under boost, then you need a different spring friend ;). Research your specific BOV (when you find out what particular one you have) and find the right spring that you need (you'll need a spring rated to stay closed between 20-25 in/hg). A tial...

^What in the hell? :confused: