Search results

Only issue I have with it is the compression fitting being re used multiple times. I ordered a new nut, compression fitting, and pipe in a long list other things from the dealer, and turns out the pipe itself was discontinued. I have a new nut and compression fitting but no pipe to go with it...

Haha thank you for the kind comments guys, means a lot. And suprakidd I am going on vacation a while but later this summer we should get together or something, you could come to one of the local meets.

Finished product :D Not a single leak!

Good luck. The driftmotion kit is nice, I used it on my head and it has held up nicely. Word of warning, there are two studs towards the center that locate the manifold, if you look at the manifold you will see that the holes are smaller. Make damn sure you get these two on there straight or you...

Thanks man. Yeah I am running stock ECU but speed density with the maftpro.

Just started her up for the first time! Fired up really quickly. http://www.youtube.com/watch?v=DUKcQIW9Q5M&feature=youtu.be

Any updates?

Ya I am going on vacation in a little over a week so I am trying to get this thing fully functional before I leave. I wish so bad that I had AC in my garage lol. The fact is that I live in an apartment complex, and technically speaking we are not allowed to do any work on vehicles anywhere on...

http://www.mkiiitech.com/forum/showthread.php?t=1001&highlight Here's something to get you started

That is the knock sensor harness for another vehicle, you have to use that one to repair your wiring. If you want a direct fit kit, you need to talk to Shaeff on here, he used to build them and sell them, but to repair them on your own you buy that part just for the new connector pigtail...

Nice thats a good price. Those in the pic are from Harbor Freight, but I think I paid $12 or $15 Engine is in, now just hooking everything up.

Ya the rear port would probably be ideal but I am not too worried about it. The front one was tapped (this is an NA block) so the deed is done. BTW here is my water pitcher for dealing with my 100+ degree garage. Home made insulation, then it goes into my playmate refrigerator :p

Yeah I put the rear knock sensor in the hole closer to the front just for access. The rear sensor went bad on my last motor and it was nearly impossible to change without removing the starter, so I moved it up to the front hole and never noticed any difference at all, but it is a lot easier to...

Haha only IJ would have a brand spanking new 7m head :D Custom wastegate from Albert. Ported the WG opening and installed a larger flapper.

15 too young 36 too old 24 just right ;)

I bought mine from Napa and it is noticeably lower quality when compared to oem, I have it sitting on my desk I can snap some pics if you want. The section of the tube where the extension pipe slides in appears to be oblong, I highly doubt it would seal properly with the stock O rings. I will...

Alright, it is time to kick it into gear finally. Been super busy the past couple weeks and haven't had any time to get stuff done. Some progress this morning. Should have the head installed tomorrow, and engine should be ready to go in by the weekend if everything goes as planned.

I like the part where it explains the conditions under which overheating (entering the red zone of the gauge) is normal (in traffic with AC on, and low speed driving after leaving the highway IIRC).

Sorry for the shitty pics but this is literally all i could get before the battery died on my camera. I have searched my place up and down and can't find the charger anywhere. Hope this helps a little.