Search results

-:|Update - 2010-05-22|:- The wheel arch putty hell continues :) Pictures: Right side Left side

-:|Update - 2010-05-16|:- Today I started taking care of the looks of the rear wheel arches. I want to be done with most of this so that I can give the putty some time to sink if it wants to while I do other stuff with the car. Now in the beginning I'm using fiberglass reinforced putty...

-:|Update - 2010-05-15|:- This day was dedicated to electrolyte bath. I actually started yesterday so that it could sit during the night. And I did help the process some by sandblasting. I was running low on time for this so I couldn't complete it and make it ready for paint. But the...

-:|Update - 2010-04-26|:- Didn't do much today. I just looked a little at the harness which I need to get started on. Pictures: Started looking at the harness

-:|Update - 2010-04-23|:- Today is the second day that I can mount parts on my car :) I took my time with the oilpan and cleaned the flange good and then applied a layer of gasket on tube and installed it. My pan has a level sensor but there is no cable in the enginebay that I can...

-:|Update - 2010-04-21|:- Today I continued with the front subframe and oil pan. I thinned out the paint and painted the parts with a brush, turned out ok. Pictures: Comparing sizes Top coat is on

Nice setup :)

-:|Update - 2010-04-19|:- Continued with the subframe and started on the oil pan and ended up with both parts primered. I grinded the parts almost non-stop so that a friend could help me carry them outside to a temporary tent we made. The primer was put on with a paint gun. Pictures...

-:|Update - 2010-04-18|:- Didn't do so much today. Just brought some stuff to my garage and cleaned the subframe with degreaser and water. Front subframe bushings and hockey pucks for engine mounts Clean front subframe

Nice find, congrats :) Now, keep us updated with your work

I'm using MS2 PCB v.3 in my other project so I will continue with MS. On my supra I will use MS3 instead. So far I have built 3 MS2 and my own and I will continue to do so.

But those are more expensive :) these will cost about 55 SEK per side. I don't mind the harsh way of solids and these still have some flex in them. Thanks for reading

-:|Update - 2010-04-17|:- Today I did some touch up on spots that I had missed and painted thin on. I also painted everything red in the rear that is covered by trims and bumper. The front subframe bushings got out very easy and the look new so those must have been changed before. Anyone...

Thank you :)

Thank you very much :)