Search results

If you have a vac leak chances are it turns into a boost leak when you start spooling

I use a switch that goes directly from the battery to the starter because my wiring is bad at the ignition. Since installing the switch I always start the car like this (when it is cold). I turn the key to START for a few seconds to run the pump. Or else there isnt enough fuel to start the...

The electronics are THE SAME. The housing is different

I have a cooleeze its the same way. Can't fit the wratchet wrench on the one bolt.

Remember to get the right size bearings. No one seems to mention that

Is that another 40 on the roof?

then all the proud usdm boys would stop watching it. You're right about needing skill to rebuild supras. Which means there aren't enough people to reach out to for a show like that.

lol I feel like im on SF again

So True. People think its aftermarket sometimes

you should check it out. I didnt really notice until i did a pressure test. Right when i applied pressure to it it was leaking at the turbo and afm. The worm clamps broke before they would seal

Ok thanks guys. Square it is.

Just to let you know. The caps don't seem to be air tight. and It leaks unless you use T-bolts. worm clamps don't work well. And thats what they send you. It doens't fit the Lex afm properly either. They say it does but thats only if you really force it on. Then it denfinetly won't seal...

If your mounts are square can you still use the round ones?

i like the gracer better too. but sometimes (maybe it depends on color) I like the bomex too.

lol. Well I may give it a try. I won't be able to measure the difference though.

I think its for athletes foot

Well in theory it works then. But our mani's wrap around and go over the motor. Not straight away like most hondas. So with the extra exposure to engine heat who knows.

great thanks. im rebuilding in the fall. Only other worry on my mind is how brittle the wiring harness is. It was cracking and falling apart last time. I hope it can take another rebuild.

I should have done it myself. He will be paying for it if thats the problem. Im doing it this time. I know alot of people he knows he'll be sorry if he tries to get away with it. He is a good guy from what ive seen so hopefully he will help me out. Thanks guys. Im using an HKS gasket...

what?? really. Could it be a rivet? would it crush enough with a rivet to have just an oil passage leak? This was a reputable machine shop. They put the head on the block. He told me after that he researched cometic gaskets and said that they need a spray to seal properly. is he lying? what...