Search results

I have pulled all but one of my 7M's by my self. Slow and steady wins the race ;)

Anyone with access to a wire feed welder and an angle grinder, can make there own for $40. ($20 for each bulge/side). No I didn't do it. I found the web site like 1 month after installing my 7M.:cry: I wish I would have found this site before I installed it. I still might "redo" it this...

Only to remember to unhook the two harness that lead to the tranny. I just "cut" them and reconnect them when it is time for install. I have removed 6+ 7m's this way. I have never unhooked the tranny to remove the engine, I just think it is easer to take the two out together. You will also...

So let me get this right what you are asking, You have this: 7MGTE & GTE TCCS You bought: Supermonitor and computer from a 7MGE You are asking: Can I install this and have it "work" with my GTE, so I can check codes and such. (if MPG is off that is ok) My answer: I...

I like what Rich said. This doesn’t there locking the doors tomorrow. Look at Northwest air lines (a U.S. company) they declared bankruptcy, got shit in line and now they’re not in it anymore. Just a way to not pay the bills for a wile. Now maybe the fuel prices might put NW back...

Doesn't Jack (suprasport.com) offer the harness also? <as he goes to check their web site>

You are correct, the 7M is a high volume, low pressure system.

:naughty: I removed the bolt wile my 7M was on the stand. It took a little "american ingenuity" but I got it off with a 1/2" breaker bar, 5' pipe, and the GF to hold things in place so the whole thing didnt fall over:biglaugh:.

WOW, is what I have to say. 60 million, dam that is a LOT of R&D. This is too bad for them, it is never good when a major player in the performance world goes under. I wonder if theres more to come?

Figgie, dose it take your dial up to long to load photobucket/imagestation pics? or whats going on that you don't like them?

Well not too much to update, but let&#8217;s see what has all done lately. I finial found a gauge cluster from a 89 (missing the tach) so I swapped in the missing gauges into the cluster. Since I had it apart I bought a volt gauge from a N/A for $12 shipped of eBay so that also got that...

JJ, it's in the mail. Thank you again

Yes that hose is a pain to replace. Also make sure the heat shield for that small hose is in place or else the heat from the exhaust manifold will destroy it. Lots of good info on this thread, I think I even learned a few things.

^^^ LOL, that look like my sig. that I asked ERA to design.

Ok, that is the one off ebay. thank you

Did you get it from Seth ? Or where did you buy it from? I can only find it on ebay:(

^^^nope

^^^ yep that is the one I like. Jdub if that is yours you the man!!!! Will the 80mm work with the turbo I am planing on? gt35R, gt37R, or maybe even the lag monster gt42R

^^^ yep I saw that. I asked Arron what TPS it uses (Im post #3 ;)) But thank you! I was looking at that one, the blue TB (earlier in this thread)for $100 more that uses our stock TPS, or a mustang TB with ford TPS. Not sure what one I should go with. I can just see though if there was ever...

Silver/light gray thread could be used for the chrome. Size? What ever size would look good on a head rest. I am guessing some where around 4" wide or so. The hard part I am guessing is the the 6 different colors that would be used.