Update. Fixed my throttle cable problem with the use of some big ass spacers
And now the engine is finally starting to enter the final stages. With the turbo elbow and v-band welded its almost ready for the final bolt on
The turbine housing just needs to be coated and then the...
Working on putting it all together and the throttle cable doesn't fit? I got the 2jz-gte throttle cable from driftmotion but its too short and its not much different from my 7m one. Did they send me the wrong cable? I already had to modify the bracket to make way for the wiring harness reroute...
Big update today. Finally started to get shit done again.
New motor went in once i got a new clutch disk for my ACT 6 puck
Connected the two for the first time and had a big grin
Then rolled the car out for a quick engine bay wash before the motor went it (Gotta keep it clean)...
I think i figured out it was because the engine brackets are for either a jzx90 or a toyota soarer, but (I believe) they sit way higher than the jza70 brackets, So the transmission wont bolt up with the firewall in the way since the motor is sitting up too high. But i could be wrong, however I...
Test fitted the motor, engine brackets are wayyyy off. So after i figure out a clutch, new engine brackets and the power steering (if anyone can help me with PS that would be great ;) ) THEN maybe ill get the motor in and hopefully make some progress again...
Hey guys, I'm sure this is the most basic of basic questions when it comes to swaps, but i was always under the impression that the 7m and the 1jz shared the same engine brackets and mounts past 1989 when they switched to round mounts. But measuring them up the engine sits 3 inches further...
Manifold is finally back and still isnt great... Also got my t4-t3 adapter. Probably going to end up getting the adapter just welded to the manifold
Also got the motor out last weekend
See ya 7m.
Finally the two together
Plan is to start putting the new motor in this...
My favorite supra of all time just got BETTER?! WHAT!!!??? Cant wait to see it with new paint. Super excited to see what else comes out of this build in the future, Keep it up!
Thanks everyone!
Really excited to get it on the dyno but i'm going to doubt it will make much over 300whp (if at all) untill i can get some bigger injectors and figure out what to do for Piggyback or standalone. Wastegate is a 12 psi spring and the turbo should have a much better flow than...
Okay, It just seems like a lot of plugs and im curious what each one would be originally connecting to, I guess ill find out when i get the old 7m out... it is in fact a 4 row pin, Soarer wiring doest match so i guess that would make it jzx of some sort. I'll also mention this is being swapped...
One more thing i forgot. I cant figure out what these plugs are for, They are in the part of the harness that is after the firewall with the ecu connectors. Some of the wires also loop back into the ecu. Im guessing some are for the gauges and maybe another for cruise control or something? but...
Hey everyone. I might be asking a little too much here but I really need some help with this wiring harness. I'm totally stuck on what this harness is out of and not a single wiring diagram is matching up (wire color's) If anyone can help me figure out wtf this harness is from i would...
Hey everyone, need some advice quick. So i started mocking up everything and it all looked great but, The flange on my manifold is not very flat. to the point where you can feel the curves, dips, uneven-ness just by running your finger over it. It dips down the worst right where the flange...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.