Search results

When your burping the car you may want to turn the heater on also. It will open the heater valve and let water flow through. I followed Nosechunks directions but had the heater on. Never had the waterfall sound again. Steve

the two bolt are at the top of the engine where it meets the transmission. You may want to loosen the engine mounts and the transmission mount and tilt the engine so that the trans is lowered, it should give you better access to the top bolts. As far as the starter, you may want to remove...

bad fan clutch? when you went WOT, the fan was spiniing faster and pulling more air thru your radiator and the sensor was sensing the cooler fluid. Just my geuss- And it is always a good thing to check all fluids!! Steve

Check to make SURE that only one side is grounded. Check to make sure that the place whare your grounding the ONE side is really a ground. Use your meter to check that your on a ground. I cant say this srongly enough, my wireing was correct, but I did not have the shield ground properly and as...

Hi John- The other night I searched for information on KS. What i found is that in order to properly test the sensors themselfs you would need a oscilloscope. The KS put out a wave signal that you cant test with a conventional VOM. So i performed test that are similar to what you may have...