Search results

Anyone else having troubles viewing Rodel's photos? It seems the thumbnail is a default image, and clicking on the image itself suggests the page does not exist.

Welcome back to the site and congrats on the successful motor build. The site seems to have slowed down a lot in the past few months, but there are still active members. Good lucking sourcing your parts and looking forward to pics.

Any update on tracking number? Thanks

Anyone have pics of the Genssi installed? Cutoff patterns, etc? They have decent pics on line, but I was hoping to see someone elses results.

Thank you for the update. I've put this off for too long, so I'm excited to see the change this makes in my car.

Any update on yellow kit? Just curious!

Looking forward to it.

You've got payment for front and rear yellow subframe bushings. Thanks! :)

That's great to know guys. Thanks for the help. I'll double check the seals and go from there. That being said, on the freak chance that a rear arm were to go bad is factory toyota the only option?

I'm in the beginning phases of mky MK3 suspension rehabilitation (the purchasing phase). I currently plan to purchase: F&R sub-frame bushings(poly), F&R Energy suspension poly bushings, new spherical bearings in the rear, Front lower ball joints, tie rod ends, and wheel bearings I already...

Hi, I'm ready to order a set of front and rear in yellow please. I can paypal when you are ready. Thanks

"I now plan to check the voltage in Mode 1 by having someone hold the motor at 2500RPM while I connect T and E1. " That's the plan. Thanks for the help. I've been out of town a lot for work lately, so it's slow going, but I'll post back as soon as I've done the test.

Thank you for the wonderful resource, it directly addresses my questions. Based on this new information, it appears that I was attempting(poorly) to check the learned value of Vf. Did I accomplish this by checking Vf, and E1 previously? how would I go about measuring Vf if I did not.... In...

i just took a look at this thread: http://www.supramania.com/forums/showthread.php?47017-WAY-lean-at-idle.-18-AFR-s.../page4&highlight=vacuum+measure Looking at posts 19(yours jetjock) and post 21 I should be checking E1 and Ox instead of Vf @ idle. and looking for the following readings: 0.00...

1)Well... excuse my terminology. I should have stated "checked/connected" the terminals E1 and Vf on the diagnostic block using my DMM. I did not actually short them to ground, but rather placed my DMM terminals on E1 and Vf respectively, measuring 0.033 volts. I think this is the correct way of...

A much overdo update: I've made a bit of progress on this and I wanted to double check my findings with the experts here on Supramania. 1) I checked fuel control by monitoring the Vf signal at idle by shorting E1 and VF ports on the diagnostic block. As expected, the voltage was near zero...

I'm interested and located in California. I'm wanting a front and rear kit of yellow subframe bushings. Can you PM a price to 92307 California please?

http://i0.kym-cdn.com/photos/images/newsfeed/000/173/576/Wat8.jpg?1315930535

That's the plan. O2 sensor fist, and then fuel system.

That's the plan. O2 sensor fist, and then fuel system.