Search results

I think you can get wheel bearings on ebay but i cant remember if i seen any recently. I dont believe they were too much money. Im not sure but i think you can use a dial indicator to check a wheel bearing if you have a repair manual look up the procedure on it to find the specs and how to do...

Thanks for the help all. Maybe while i have it ripped apart i might put new internals in it. Ill finally have piston squirters too. Ill take your advice on the k/s shaeff thanks. Ill Take this oppurtuinity to start a new build. Does any one know how much boost stock pistons that are...

I had a rod knock which caused my motor to blow. It was an NA with a turbo setup on Na electronics. Can i put in a gte block ,pistons,rods ,and crank. I heard there are 2 knock sensors on gte and one on the ge but i still have ge harness on my setup. I just want to swap out with bare block, will...

I filed the black plunger like tsuper92 did and it works fine i only had to take a lilttle off. Pops every time.

If your wondering if its working crank it in alot and go boost it but if you hit fuel cut or too much boost let off and drive it normally home just take it easy on it. I think i heard 1 turn is like 1-2psi?

car 2000, new head 450, hks hg 225, clutch 250, stereo system 400, interior parts 100, paint 500, mbc 25, gasket kit 125,arps 110, belts and hoses 60, plugs 30, new exhaust 250, And the list goes on I would hate to count all the hours in labor i put in it lol. Oh and just bought another for 250...

You can do it I have my 7mge setup with a turbo right now. You will need to watch how much boost you run do to the higher compression. Keep an eye on your egt's and dont run it too lean so get it tuned. You will need to drill a hole in the oil pan for a oil return from the turbo. the injectors...

I have a mbc from dr jones how do you hook it up to an external wastegate. There is one vac line on the wastegate and there is a barb fitting missing where another one goes? I dont know if i need it because there is a vac line on the side of the wastegate. My turbo doesnt have the vac line like...

Thanks for all the help, yea i did watch a video on streetfire.net with him racing a vette.

I have a na-t 7mge block and was wondering if i could get a set of pistons for a gte to fit my ge. Does any one know the stock bore sizes on both 7mgte vs. 7mge. I am trying to avoid detonation so i need the lower compression pistons. thanks steven

I just wanted to say thanks for all the advice. I am going to see if i can get to idle this weekend because i am away from the car now. thanks Steven

I have a 4psi spring in my hks wastegate. If i would buy a mbc off of drjonez could i go over the 4psi or do i need a new spring. Thanks Steven

well thanks for the info

bump

I was wondering if the hks filter adapter will fit both n/a and turbo afm's

I just installed a new clutch in my car and the battery was disconnected for 2-3weeks. i have a 7mge with a turbo kit on it. i took the exhaust off at the downpipe beacuase the rest was shot. So i have just a downpipe on the car. I only ran the car for about 10-15 mins but it wont idle. Does...

How do you hook up a mbc to a external wastegate. Its an hks wategate and i am running 4-5 psi and i want to run around 9-10. and what would be the best mbc to buy for under 150. Thanks steven

I have a na-t without the oilcooler and the cars has given me any problems yet. Good luck with the build. Steven