Search results

There is single wire ground connection on the coil pack assembly.. double check..

I have a Clutch Master Stage 1 with ~ 14 psi boost.. never had a slippage..

my differential is leaking oil on the front and one of the sides. I bought seals from Toyota. Is this a hard job? I looked at TSRM.. there are some SSTs mentioned.. have anyone done this without SSTs? I dont have a slide hammer.. is that required for the side seals ? Luke. 87T (with some mods)

to take the seal out, use the seal remover from auto-zone or some (<$10) and to drive the seal in, i would get a piece of PVC pipe that matches the diameter of the seal, and use a wood block in back of the pvc pipe, and tap with a hammer. If you are taking the tranny out, replace the seals on...

Two times I did the crankpulley torqe is as follows: 1. jack car up high 2. remove dust cover between engine and transmission. Its on the bottom back side of the bell housing 3. put a pry-bar or large screwdriver in the teeth of the flywheel and wedge it against the bell housing. 4. have...

The center bearing on my 87T M/T propeller shaft has little bit of a play in it.. the shaft can move sideways (about an inch). The rubber part as well as the bearing is moving around inside the housing. Time to replace? Also, i saw some notes (before SM got hacked) about one-piece shaft.. i...