Search results

Hello, I have some funds coming in soon minimal 500$ should be more. Anyways my 7m has been redone and is almost like new running great after the swap. All I have right now is a 3" give or take local shop made, a 3" dpp and is otherwise stock besides the new headgasket with arp studs and torqed...

Fixed all the bigger problems with my swap. What's left over is mostly just fuelcut, slow start, and a high idle. The cold start will work properly around 1500 rpm. I drive slow out of my housing area, and it's at a good idle right at 1000 rpm. Drive for a little and then it'll always be at 1400...

I'm wondering what kinds of things you guys have done to make your car feel nice new whatever again? I have just done things such as better sound insulation, floor matts, deep scrubs and clean ups. Next I'm looking to remove that annoying mirror wind noise and somehow make my door shutting sound...

I'm wondering what you guys do to make your clutch pedal feel good again? Mine has a super short engage right off the floor and half of it is freeplay. The clutch is new. Sometimes when I do a hard engage or ride the clutch on a heavy acceleration all my fluid just spills out. I think it's the...

Hey I've dealt with this issue for awhile I thought the turbo would completely fix it it only helped a bit. Current my exhaust is 3" all the way but right before the bumper it's like 2.75 or something for the bend. I have a ebay resonator and a summit racing full sized muffler...

So my A/C quit working before I did my engine swap, the clutch quit engaging I didn't do much diagnosis back then. But now I've tested a few things, the 10A fuse is good. The one pin plug is plugged into the harness. The clutch piece spins freely no bearing noise. My A/C light stays on it does...

So got my turbo motor and everything running it's awesome. I have no boost gauge or sensor figured I'd just save for a boost controller for the two in one. My only mods are a 3" dpp with a 3" exhaust. We didn't mess with the block but the toyota mechanic said something has been worked on before...

So a fellow member here sold me a 373 LSD rear end for my 89. After I got the engine all in I started driving, hearing some skipping or bouncing noise, Oh shit we did the clutch wrong... But then I took another sharp turn I noticed the inner wheel would be locked up and skipping or skidding on...

I don't know why I'm posting this but after all that work and having no idea what I'm doing and modding the harness a bit it was able to start up :O https://www.youtube.com/watch?v=iT93PBdt3mI Just got one oil leak and PS leak to fix which I already found just have to tighten clamps...

I have an issue. 89 body Grey plug and a 90 auto harness. There are two big cube shaped dark Grey plugs that go in the glove box next to the ecu plugs. They do not plug into each other but have very similar wite colors. What should I do? Cut the plug off of my 7mge harness and match wires and...

I've figured out I need a 32:10 speedo gear set when I have a w58 with a 3.73 rear to get my speedo within 1mph accuracy. Any idea? My toyota dealer wasn't so helpful..

Going about my swap everything going pretty solid. Engine head rebuilt, all back to together, new clutch and trans in and bolted up. I'm just going over wiring to make sure I have no big deals. I've noticed 2 wires cut on the 7mgte wiring harness, one goes to the 'c1' male connector as I've...

Been looking around I'm still a bit of a noobie with rebuilding an engine when my dad has dont this before. I NEVER knew how expensive hoses and gaskets really are. We already have all the main seals done, felpro head gasket with arp head studs and all. I'm wondering what gasket sets you...

Just wondering what you guys think of the ABS system on our cars. I drive in a snow a lot so this is important to me. I've noticed with the supra braking hard in snow, when I hear and feel the ABS turn on it's much worse braking than if I just pressed the brake pedal right before the wheels...

My current brakelights are warped from leaving it too long in the oven, I took some of my parts car but they were tinted. I ordered new LEDs and all that but the turn signals aren't bright enough, I figure I just want to remove the tint because I don't like it anymore. I tried carp cleaner and...

I'm looking to get a HID system with a d2s retrofit on the sealed beams. That wide and bright light would help me a ton with night deliveries and I just miss the nice light that actually lights the road. Yes I deliver pizza in a mk3 supra and it's awesome. I've always seen forums constantly...

I'm wondering if anyone has done this before? I'm wanting to replace the corner lights with clear ones. Put crazy bright clean LEDs in the parking light slot and use them as DRLs. I enjoy the added safety because my white car blends into a cloudy sky too easily lol.. I'd rather not run another...

I have to drive the 7mge supra for awhile now because my spare car to drive while we swapped the 7mgte in the mk3 quit working. So we fixed up the supra to drive again, aka replacing the water pump. I also fixed a slight intake leak where the rubber sealed over top of the metal tube that goes...

Hey had some unfortunate things happen... Supra water pump froze up so we got a eclipse to drive while we do the engine swap for the supra.. Now the eclipse gave out so I'm back driving the supra. Just regular non-turbo, since we can't swap it this year I'm trying to get it as pleasant to drive...

Hello recently purchased a 95 Eclipse GS (I think) for 1000 as a temporary car to drive while we do the engine swap on the supra. I just wanted to list a few things that are wrong with it and see what yo uguys say. Posting here to avoid making account on DSM forums. - Sputter/Misfire on...