Search results

I'm looking for any information on a 1974 Datsun engine wire harness. I have an all original Z that wont start. Traced it back to the ignition wiring. Looking for a new or good condition engine harness, or info on a company that sells them. Trying to keep it original and not just make a harness...

This is a better section. How thick of a plate are you talking about? Couldn't you ask the company that did the coating what the heat and wear tolerances are? There are some folks on here that do powder coating and other types of coatings, maybe they can put in two cents. Edit: Lets have some...

What could you possible ask that isn't for this forum...

Get in the car and have someone hose it down real good. Or set up a sprinkler and sit inside till you see where its leaking. Where is the water at when you see it?

how long has it ran since you got it back from him? Did he machine the block and the time plate on the front on the motor together? Could be the little 90 hose behind the thermostat housing and above the PS pump.

Do you have an after market FPR? If not test fuel pressure at the rail while running to see if your loosing pressure, or not getting enough. Use a stethoscope or screw driver to listen to the injectors for any odd sounds other than a steady tick-tick-tick. Sounds like you have changed all of the...

Vacuum Switching Valve. Check it out on the TSRM. Call Champion Toyota, or your local dealer and pick up a new one.

Where is your boost controller located at? Could be a boost/vacuum leak. If it really sounds like a BOV, that's strange. Might be an exhaust leak squeaking by the turbo gasket. There's not much that sounds like a BOV that's not a BOV. Check to make sure that the BPV/BOV is working and your not...

Welcome, the forum can answer any questions that you may have if used properly. Please use the search button first and then ask away. Please post pics of any of the afor mentioned cars...

Scam. Ive seen that car(CL posts) around too.

What trans do you have in it now? Every transmission has a reverse light switch in it, on it, or around it. Take a minute and look at the TSRM for the given trans that you have. The TSRM will have the diagram showing where the reverse light switch is. should be able to hook it up to the existing...

Whats the weather like up there? Barometric pressure? I'll throw down a guess of 395hp and 379trq

Did you clean your old pistons and put them back in the newly machined block?

does it always rev that high at idle? Take a long screw driver and touch the business end of it to different places on the block, head, oil pan, intake, exhaust mani ect. *+BE CAREFUL+* of moving and or hot parts. Watch loose clothing and fans... Put your ear to the handle end of the screw...

Putting the Lex AFM on is just a band aid for the real problem. Find some free time, jumper the diagnostic terminals and check the timing with a proper light. Make sure the car is warmed up and keep the A/C off. There are a ton of reasons why your car could be running rich, could be worse could...

Starter plate, Goes on the back of the motor before the fly wheel. Starter goes in the hole. Dust cover/access plate.

I bought mine from a guy who has been in over seas for years. He didnt angle the TB either but i just took some of the hood brace out, No big deal to me. Some would not think about doin that tho. He also added material to make the intake a bit bigger at the flange to imitate the taper that...

The 7mgte plug and play units.. http://diyautotune.com/diypnp/models.html

:biglaugh: Present..

I meant I like what you were thinking there