Recent content by Supraguy88t

you have pm

second that .... it's an 89-92 usdm 7mgte. gray plugs and blue sticker with yellow letters JDM purple lable

I have one similar to the one pictured but instead of it splitting before the silencer it splits before in to dual silencers on opposite sides of the diff into dual pipes. I also had one with the single tip muffler with dual silencers but I sold it to someone in canada. pics: vid...

... Japan :P ... I was able to find what looks like a Brand new Japanese greddy replica .. someone getting rid of old stock on yahoo japan.

does the alarm go off when you open the ignition switch? if it does then it is a factory alarm problem. You just need to disarm it with your key in either door by unlocking it or disconnecting and reconnecting the battery. If it doesn't go off with the ignition switch on then then it's the...

the price quoted does not include rings ... rings are extra. I knew about this last summer ... they have had the pistons in their catalog since last summer but have not stepped up to make them. As far as I know they were only going to make standard and .20 over. From what I have been told the...

shipping size limitations and outer most extremity to the other. From fender to fender.

After searching the internet for this I figured I would just post for a favor. I need someone out there with a whale tail to measure theirs and give me it's dimensions. Width at it's widest point is what I'm most interested in as accurately as possible to the closest cm would be great :) thanks...

edited : moved to general discussion

I'm Christian :) ..... I have not been very active on this forum since it when down a while back and had to be redone. Dont let my post count fool you. I'm in Garland along with several non-forum active members. So yes there are enough of us in the area to occasionally hang out.

$425 is a steal ... but I'm sure it was an opportunity thing. This would be a set price for whenever people needed them they would be on hand. The pistons are good quality. I've talked to some local machine shops that use them in their domestic motors and say they are a great piston. I'll...

The same aluminum alloy used in the JE's and Ross pistons is used by these pistons. As for price ... it will remain very close to $400 the highest that I see it going is $450 but I see it more along $420 or so.

because it's alot easier to match a bore to a pistons and not try to match a piston to a bore. so 83.5mm and 84mm it is.

Dont forget about me! LOL .... Like I said I will fill in other details later. I'm still trying to keep some of the cat in the bag ;) I just need to see an interest for the product to invest in it.