Recent content by MA702Tone

Thanks for the offers, if they are still available hit me up with what you have available please! Thanks for your time, sory for the late responce

Hi there!! How much are you looking to sell the engine that is posted on #56? Or would you be willing to part that out. I am in need of a crank, rods, and a head. I live in Oliver Springs, TN. 37840. Thanks for your time!!!

"Jonah Taylor Laugh HAHAHAHAHAHAH COUGH COUGH FLEM FLEMCOUGHHAHAHAHAFELEM HAHAHAHA BURP " !!!! That laugh is copy righted and don’t forget the V-Tech Sticker that will add the .01 lbs of boost to make it act like the flux capacitor to generate 1.21 Gigawatts to see some serious shit!!!

It may be low line pressure, if this is the case the pump may need to be crossed referenced to the TRSM for the line pressure, and the clearances for the trans pump. If this was driven for a while with it slipping and boosted often it may have burnt the clutches, and friction plates. In turn...

Rite on man!!! I hope that this will help you out, as well as alleviates some headaches haha, I was searching on this forum and came up with no results. So it came down to where I was on my own for “ make this work “ mode… in a short period of time as I went through...

Nope. Just keep your original tranny harness, and remove the output shaft housing and speedo gear from the output shaft. This would be a parts swap from the defective trans, to your replacement if you get one that is ABS. Keep in mind that there is a steel ball that will keep the stator /...

HAha This would have been awesome going through high school, this would have possibly save a bunch of ass bustings with Big Bertha :: spank :::: spank ::, or mave have possible caused all of my stuff to be setting out in the front yard, with a reply note "Dumb Ass, get your head out of your ass...

:: freezing :::: freezing :: Sorry to thread jack, though in a similar situation here with no heat :: angry :: I have completely bypassed the valve, and used the hose that comes from the back of the head to the actual heater core... still no heat. I have took the glove box out, the fresh...

:wtf:::focl::::toothless:: ROFLMAO ::focl:::: snowart ::

Hi there!! I am in the HTC Tech Support, and I am not to thrilled with the Sprint Hero.. Here is a list of the known issues with the 1.5 build lol. Hold your dam breath guys.. 1 Dust under LCD lens 2 Device shows rev. 0 instead of rev. A 3 3.5mm jack merges sound to mono 4 Unable to...

What do you do when you have 2 ass hats on a 2 lane running the same speeds, and are at the same position, which will not allow you to pass the slow asses??? And what bothers me the most is that the majority of the asshats are on the phone, or shoving some shit down there top ass holes.. What...

::fundy:::ttiwwp:

Cool cool.. I am happy for you on your build man!! Hope all continues to go well in your favor: icon_bigg what are your goals for your project?

The crank did not have any scoring, pitting nor did the cylinder walls? Do you plan on replacing the bearings ( Rods, and Mains )?

Looking at the picture of the cam :nono::aigo:, I wonder what the rod, and main bearings look like. Also wondering what the bottom of the cylinder walls look like when you cycle the engine?