Recent content by HeWhoOvercomes

Hey...sorry to bump this. What's the difference between the 86.5 (don't know exactly when they switched) condenser and those used for the subsequent years? I'm looking on TheACParts.com and there are two different part #'s, 1039292 (86.5) and 1039293 (the rest).

I'll admit, I wasn't so sure about the everything-delete, until I saw those pics. Actually looks good!

Where did you get those rear upper arms?

Does anyone have experience with Comp or BC springs with stock retainers?

Hey guys. I've done a lot of searching, and I can't find much info on either of the following questions. (Regarding Comp Cams Part# 975) So, from what I've read, these don't fit perfectly. I saw that there was some speculation over whether or not the Comp springs would wear the sides of...

Thanks guys...I talked to him and he was looking at the intake side. :P

Hey...I bought this kit a few weeks ago, and my machinist is afraid that there's not enough meat around the bottom holes for a 7/16". Seeing as I've never heard a complaint about this kit, I can't imagine this is the case. Has anyone ever had a problem with the walls being too thin after...

Any close-ups of where the throttle linkage goes through the COP plate? Is it right in the middle of the coil #5 mounting point or off a bit?

Thanks Nate! You rule. ::w00t::

This.

I know it happened a while ago, but how hard was it to get the spherical bushings pressed in/out of the rear hub? To get it out did you remove the bearing and then cut the steel sleeve? That's how it looked in the pic.

Is there any difference between the DG500 and the DG529 (not 528) besides the mounting point? Seeing that the #5 coil might interfere with the throttle linkage, and I want to use Dragon Fire, I was wondering if the 529 works with this mod. Btw, what brand of coil are you using, Diego?

How about a dashboard with built-in gauge pods? I've been looking for ways to mount gauges cleanly, but the MK3 doesn't have a lot of options.

I think I'm one of that three, but here: HeWhoOvercomes / Jordan S. / Qty-1 / Undermount / 88020 ^^and is that spacer made from the 1/2 inch tubing included with the plate?

Haha! HeWhoDoesn'tOvercome, I guess? It's a bible verse. ;)