Recent content by disturbed1

got a defect notice because the front windscreen had a crack from the hail storm. was no way it would ever pass a pit inspection. will transfer all the brakes etc over to my replacement daily (1uz a70) and try sell off all my 7mgte bits and pieces. going to move away from performance dailies...

well after 8 years, its the end of the z20 eara for me... no doubt she'll never be forgotten Uploaded with ImageShack.us

its good to finally see people rocking this brake upgrade..

looks good sylquebec. good to see someone had a little faith... what front brakes are you running?

4 months on and people are still skeptical about fitment... was kinda expecting somone to have bought a pair of front calipers to see if they bolt right up aswell

cusco zero2

Thanks for the help Chambers. Havent felt like crawling under the dash to finish off the other connector just yet so decided to put all the pins for the 1uz (both ecu and chassis loom into excel. (may help someone in the future. i went through the whole tewd for a sc400 and wrote down...

not yeat mate, will be a fair way away from that. concentrating on my other project car atm (1uz into a70) but will get the track supra up and runnign with the r154 to start will as its already all bolted up

Chambers, didnt plan on cutting any wires - hence why im looking for the matching plugs for respective looms. picke dup the chassis loom plugs for the 1uz engine loom already. heres the 3 plugs on the chassis loom. view is of the female plugs looking at the pins (NOT the wires) "-"...

hopefully someone on this forum is a ga70 wiring expert (peewee??) or can point me in the direction of a ga70 wiring diagram as the tsrm one just not cutting it. im 99% sure after pulling out the auto 1ggte from the 1990 non abs ga70, these three plugs where the only plugs beside those in the...

Hello, would like know the overall height of either a na 2jz w58 or 1jz r154 bellhousing if anyone has one laying around. Cheers

didnt get many replies so decided to just buy one and give it a crack. Took the cheap option and picked up a used opimum v 7.25" clutch off ebay which was going for 230 usd delivered to Australia. about 80 usd cheaper then any other, and had the most life left in it still (current specs...

not keen on os gikens, thin plates that warp very easily and expensive to rebuild. not to mention, not sure hwo easy it is to change hubs over on their clutch plates as i need 26 spline GM here are a few pics of the NPC twin plate i have (for those interested).

to cut a long story short, not sure how many people here have heard of NPC clutches (aussie made) but I have a brand new twin plate to suit 1jz/r154. I havent heard a bad thing about them and two of my mates who run them (1jz and rb26) rave about it. Drive like factory and rated to over 1000...

process on supra is very slow to nill atm as im busy with work/uni so jealousy of josbeat's 6 speed sequential quaife had me thinking... as much as id love a sequential - took the cheaper option and just bought a gforce gf4a...hopefully it will save me money in the long run by not havign to...