I'm doing the wiring for a 1jz swap and realized that I only have the b1 connector. Pics below. Anyone know why this is. I've been unable to find anything on this online.
Strong and valid points, we were hoping the car would turn up giving the mechanic the benefit of a doubt but felt like the guy just had the car towed and scrapped. We still have the police report and records plus the receipt; and yes Canton, Ohio.
My brother had his supra "stolen" from a shop where the car was getting a headgasket redone at. Here's the story:
In summer of 2008 in july, I had a friend's dad who had done work to my other supra take on the task of taking care of my brother's bhg on the 7m-gte. My brother needed the car done...
No, I ran a new wire for the injector driver, that ground is what i ment. I ran i new wire for one and four. I found it to be powered by the orange and black wire at the B1 plug under the dash pin 17 for 1989 ma70's
I had an issue with the injector wires so i ran new wire for the grounds but dont know where to run power for them or what they get powered up into the harness. :1zhelp:
I suspected my igniter to be faulty but turned out good, figured I should post these results to see what you guys on the forum think.I found the online igniter pinout for the 1jz and and here's what I got:
pin 1 and 6 = 1878
pin 2 and 5 = 1888
pin 3 and 4 = 1897
pin 7 and 12 = 1877
pin 8...
So this green wire is at the kick panel? not to confuse things but im helping him. One of the other isses we're having is getting power through the harness. Last test for power in the harness we got .08V??
When i had 550''s in it i initally didnt pull anything. I have the neo pulling -6 at 500 and -11 at 1000, I will increase pressure. thanks for the quick response, much appreciated!!!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.