Recent content by chris1039

When im driving then i put it in neutral to slow down and stop it idles for about 3-5 seconds then dies. It sounds like it would if you turned the key off. I took the iscv and cleaned it. Im letting it idle right now, im about to take it out to test.

I checked and I didnt forget about the vacuum line. When you start the car it will idle around 1100 for about 5 seconds then go down to about 750 rpm.

It was dumping mass amounts of fuel with the old afm. BTW i reset the ecu and code 11 went away. I checked the wire (which was thought to be brown) and it's fine.

Now im throwing code 11 ecu power source. No it stalls when i have been driving, not just when it's cold.

No i removed the iscvalve and inspected it. It is all clean.

it clicks open and is all clean... I rechecked the codes and now it's throwing code 22, coolant temp signal.

My old afm died so a bought another from a member on here. It seems to be working good except when the car goes back down to idle it just dies. Its not throwing any codes. Any ideas of what it could be?

when i shift to second and floor the pedal the car seems to missfire and cut out whenever i start to build boost. i was getting a code 24 but i reset the ecu and drove it for a while and it hasnt come back

What year sc400 do i get the lexus afm from?

i bought the mr2 adapter and it works fine with the stock manifold and the t70 turbo there is about 1 inch of clearance

I decided to just get the adapter and hope it works out. I have only installed it on the motor out of the car so far but I should be done building it this weekend I will post pics once its in.

Ok that's what I thought but I wasn't sure thanks.

How do you remove the wrist pins from the stock pistons. Without damaging them.

Is there anyway you can show me a picture. I'm going to be running a super t70 and was concerned because it kind of big.

i was actually just looking at those im worried about clearance with the strut tower.