I'm trying to install my Walbro but I can't seem to get this fuel line apart.
Just in case I'm having a moment and doing it wrong, can someone tell me how to separate this line? I have been using a wrench to brace the smaller part (bottom part in the picture) and another wrench to turn...
Well when I revved the engine (haven't actually driven it yet, and only revved a little) the afr's dipped down into the safe range, but went lean when I left off the throttle and kinda freaked me out. After doing some more reading I found that this is normal when letting off the throttle. This...
2012 University of Maryland Spring Meet for Charity
hosted by College Park Tuning
• Thousands of different cars
• Dyno pulls
• Live DJ
• 50/50 Raffle
• Raffle PrizesWe will be asking for 1 non-perishable food item per person and $1.00 entry fee. If you forget to bring an item or prefer not...
2012 University of Maryland Spring Meet for Charity
hosted by College Park Tuning
• Thousands of different cars
• Dyno pulls
• Live DJ
• 50/50 Raffle
• Raffle PrizesWe will be asking for 1 non-perishable food item per person and $1.00 entry fee. If you forget to bring an item or prefer not...
I assume you're referring to my sig. I haven't installed the Walbro yet, so that's probably why it's lean. I just finished the engine swap and the Walbro is next on the list, then I'll make adjustments.
Thanks for the responses. The battery is grounded on the wheel well and on either the engine mount or the block, I can't remember at the moment. Power goes to the starter and the small wire that runs under the fuse block next to the battery. Unfortunately it won't be until next weekend that I...
Thanks for the response. Would the fact that it was cranking slowly while being jumped rule out a battery/alternator issue? I still plan to have the battery charged and I'll have them check the alternator also.
So last week I was finally able to start the car after swapping in the turbo engine. All fluid are filled. First start after the swap took a little cranking. I let it run for about 30 seconds and started hearing a rubbing/rattling noise, so I cut it off. I looked around and couldn't figure out...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.