Recent content by 122578

hi guys i been fighting old wires and brittle connectors. now that there all replaced im having trouble with my car leaning out only when 1st WOT and i noticed my crusing afr is richer than normal (15.0 is normal - 12.5 now). i thought it was the TPS so i replaced it. still having same lean...

thanks for the help.

I know I'm not the only one that has the old bridle wiring harness problem so i was wondering what everyone does when the oem connector finally crumbles (stopping short of replacing the entire harness). I mostly splice mine together when plugs are not necessary but now the tps connector broke...

hi guys. just setting up the maft pro system and when i started up the car everything looks and sounds fine but the engine stalls briefly when accelerating. i noticed the tps signal is not reading (0.0). im replacing the neo by apexi, tps is the same pin with maftpro as with neo and it read as...

very possible. i checked all my wires when putting the new one back in. everything seems fine.

dont ask me i never have a reasonable problem.

turns out it was a recently replaced thermostat. i took it out and it ran fine. put it in again and problems came back. thanks 4 your help.

thanks i really appreciate the help.

yes i cleared the codes every time. i didnt check the ohms of the temp sensor. i cant find the info on what signals to check 4. i want to test the afm wires but dont know how.

i was wondering if anyone has had these two codes together? 22 - temp sensor 31 - afm the car runs great driving its just at idle were everything goes wrong. after starting the car it runs good till the rpms return to normal after the choke lets go. then the af ratio goes rich, the idle...

does any one run a dual port actuator? having problems controlling my boost since i got one. I've hooked it up two different ways and can not change boost through my boost controller.

i was wondering if anyone has installed a turbonetics turbo. the factory style water and oil lines and accuator dont mount up. what to do to fix this? im sure you can buy the accuator but the water and oil lines are the problem. can i buy flanges or do i have to make them?

i was wondering if anyone knows how to set up the sensor calculation on the afcneo for the lexus afm?

i tried to start my car 4 the 1st time after the install of rebuilt motor and heard a pop like a fuse when i turned the key to start. i found the problem but still no power to anything all fuses check out. what else is there if not a fuse?

i ordered rc 550 injectors for my supra and when i received them the injectors have a square connection and my harness has round. no one said they needed new plugs nor did they come with them. i thought they were direct fit. is this common or did i receive the wrong part? if common is...