Search results

Hey guys, I just rebuilt my engine, been driving it around for about a month now, and I guess I didnt seat my rear main well or my drip tank caused it to blow out, either way, I need to replace it and was wondering if anyone on here had just replaced it my removing the tranny, and if so, what's...

Well if you arnt hitting fuel cut it could be your MAF. I had this exact problem where right around boost there would be a crappy jerking and would instantly stop once i took my foot off the gas. Because your only boosting 10lbs, I would think its not fuel cut, but the problem you are describing...

Just to let you all know it was the afm! It just went bad I suppose, I cleaned mine and it still didnt work, so I put in my extra one and wala! It was fixed. No more problems and it runs like a dream...Thanks so much

What's the problem with high clamp loads?

Thats helpful...thanks guys...and yeah pierce it's almost done, just ironing out a few kinks...I'll be driving it by the end of next week. Pete

I think I have determined from looking at supra's and from other people here that this plug is only on the 91-92 7mgte model...?

That hose is a pain. The best place to get it is a toyota dealership. They have pretty cool computers that you can basicly point to the thing you need on then engine you need and they can pull it up and order it. That way you can be positive as well that it is the right bends etc. Hope this...

Tommorow I am going to check the tps and make sure its set correctly, I can also swap a spare afm I have onto it to see if that does anything I have hardpipes on order, but for now I am almost positive I dont have a boost leak, and I dont have a a/f gauge so I can't tell what thats doing.....

That could be it, I have had the car on for around that amount of time now, but I will give it a shot, and try some more "diverse driving" and see if the ECU learns a little more...

Yeah I have the lexus afm but I wanted to run the stock air/fuel setup until I got it running right.

Did you check for codes? -Yes there are no codes being given at all What all did you rebuild on the engine? -The engine was bored out .20 thousands, with all new stock internals. - .20 thousands oversized stock pistons, rings, 2.0 titan motorsports headgasket, decked block...

I just finished rebuilding my engine a couple nights ago, and when I took it out for my break in run every time I would push down on the gas it felt like it would have nothing there, as in like the engine didnt know I wanted to go anywhere and was somtimes really boggy. But if I would hardly...

So I started my car up yesterday without connecting this plug to anything, and it threw no codes and ran perfectly fine...I have no clue what this thing was ever meant to do.

Could it be that his bypass valve is stuck or broken open and he is just openly recirculating air instead of holding it in? I know that this happened to my friends which led to him getting the bosch 110.

Hey everybody, I was curious about my new clutch. I just finished my engine rebuild and took my car out of a spin and the clutch wasnt half as stiff as I thought i was going to be. By no means is it weak when pushing it down but it just feels like a stock or maybe a little stiffer clutch. I have...

alright, later tonight I am going to check the continuity and figure out where it ends up in the wiring harness-plugging into the ecu and that should help me figure out where it's going. I'll keep you all posted.

Yeah the same for me, all of the other connectors are hooked up..I wondered because it had the heat wraping around it if it went somewhere around the turbo but there are simply just no places I see to plug it in after 3 days of looking....? Did you start your car without it ILikeCars?

It does, as seen in the picture..I was looking at another 91 wiring harness an it had the plug on it as well...unfortunatly it wasnt on the car..this plug wasnt on my friends 87 or 89 supra?

Hey everybody, I am helping my friend put his 7mgte back together after a engine rebuild, and there is a plug coming out of his wiring harness on the turbo side of the engine that doesnt seem like it has anywhere to go and there isnt one on either of the supra's i own. Any ideas? Thankya...

Yeah I am in the midlothian area, I am currently going to jtcommunity college about 20 min away from vcu/downtown richmond