Search results

Hello everyone. Does anybody know if anyone makes a patch harness to plug in a Stinger EMS 4424 standalone into a 1jz harness? Something PNP?

So my 1jz is cutting out as soon as it sees 9-10lbs of boost in 1-3 gears and stumbles in 4th and is just fine in 5th. I have a Stinger EMS standalone so I know its not boost cut. It seems like the faster it hits boost the harder it cuts. It goes a little lean when it cuts. My car was tuned on a...

So I got my 1j swapped into my s13 and running great. The temp when warm is at 200-205 degrees. When Im at the track the most it has hit was 220 degrees. Is this normal? I replaced the thermostat with a OEM 2jz-gte and have a koyo radiator with 2 10''fans. If this isnt normal then what would...

So I have a 1j in my s13 and it keeps cutting fuel. It didnt do it until I hooked up my AFC NEO but I unhooked it and it still does it. I also pot in a Turbo XS fuel cut defender and it didnt help. Do I need to find the Greddy Boost Cut Controller? Or is it something else? Car runs and pulls...

So my 1jz came with a ORC single plate and the release bearing is making some noise when I press the clutch. What I need to know is do I need to get a bearing from ORC or will a Toyota replacement work. Nengun.com list 3 different size bearings and I dont know what one I have. Any input is...

So I finally got my 1j running in my S13. It idles rough and has no power. I drive the thing in the parking lot and it hesitates and doesnt have power. Once it starts to rev it smooths out. The throttle isnt very responsive. The air fuel ratio at idle bounces between 12.9 and 13.1. I am not a...

I have been looking online for the past 4hrs and cant find any ECU motherboard diagrams for a 1jz ecu. I have some burnt resistors and the shop doesnt know what to replace them with since they are bad. If anyone can get me pics or a diagram that would be great. Oh and the ecu is a...

I am in the middle of swapping a 1j with a R154 into my S13 any my trans doesnt have any speed sensor. It is just an open hole. What sensor do I need to get a my speedo to work. I know I will need the interface box thing. Also what is the 2 wires on the pass. side of the trans for? Thanks.

So I had read that I can use a 2jzgte tps on a 1jz and I had my Toyota dealer get me one and it doesn't fit. Did I miss read something? When I ordered it I ordered it for a 1995 Supra twin turbo. Did I order the wrong one? Is there one I can order that will work? Thanks.

So I am kinda new on here and I am doin a 1J swap in my S13 hatch. I have lots of photos and will keep updated with lots of photos since most guys like pics and dont like to read. Pics are good. So is porn:naughty:. I named her Britney Spears for a good reason...:icon_bigg So here is some...

Hello. My name is Matt and I own a 89 240sx hatch and an AE86 hatch and a couple of other misc. cars. I am currently getting ready to do a 1JZ swap into my 240sx so I have been spending some time searching for some info on here and I must say there is a lot of good info. Here are a few pics...