Search results

Just installed a ATI super damper and the factory 7m Crank bolt will not fit in the hub of the ATI? The stock bolt has a big hub or flange that will not fit. Any suggestions??? or rather is this what ATI calls a Crank Hub??? See url. Thanks ~ Mike...

Hi Looking to upgrade the CT-26 57 Trim I am running now. Suggestions on what I can use and still keep the same Exh Manifold and aftermarket downpipe (same bolt pattern as stock) Here is by buildpage =...

The cruise indicator does come on, but i can not set my current speed or maintain that speed. It seems this happened after a AEM ECU install. Does Cruise have it's own ECU? Does it rely on the Engine ECU? Did i mis a connector under the dash somewhere? Any help is appreciated. - Mike

Looking to replace the stock ignitor with a DH 61 and would like to know if anyone has or knows of a wiring diagram (with wire colors) for the 88 supra. What I find on-line for the 89 MKIII is way different wire colors that what I see in my car. Thanks Mike

Just wondering what the benefits are with the coil-over's? Also can CO's be used to increase the ride height of the car? Reason being I went to get my car Dyno'ed yesterday and would not go on the rack due to the very low ride height of my MKIII - the exhaust flange was hitting the center...

I have been thru the TSRM and can't seem to locate a 12 volt switched source wire that i can use for the flex-lite fan controller (mounted on the fender near to the battery and fuse block). My car is not wired hot now so I can't poke around with a test light to see what is hot when the key is...

What do you think my max boost will be / or achieve with this turbo? Here is my build page, listing all of the mods I have done - I have not run the car yet but getting close...

curious about the TSRM install of this part. Has anyone tried stretching the new o-ring over the gears? will that distort the o-ring? The tsrm want's you to grind the outer gear and pin down then pound it out with a punch. Does that also allow the removal of the other "bigger" gear...

Just wondering if anyone noticed very touchy steering on the 88 MKIII - most noticeably on the highway. Just going in a straight line over 60mph, if there are any bumps in the road i need to hold the wheel with 2 hands and try to not move the wheel. Just really touchy I have installed the...

It was 87 .... out with some friends, late summer... and the girl of my dreams drags me away from a party - say's let's go for a ride in my new car. Next thing I know were doing 135 down the blacktop... I don't know if it was the car or the blond, but I was hooked! Gimme Some More! Several...

Building my 7MGTE and getting ready to install the EGR block off plates, i see on many sites offering these plates the following: "If you leave the EGR cooler plate and just block the hole on the intake side of the head, it causes heat buildup in the head and the #6 cylinder, leading to blown...

Having a hard time finding a good engine builder in Cleveland Ohio (or nearby) that knows the 7M engine good enough to do the heads and block/internals Any references? Thanks in advance for your suggestions!

Bought a 88 Supra Turbo and made some minor adds to the exhaust, Air intake and the downpipe. Next looking to get 400HP out of this car which is in great shape. I got a good idea of what i need to do to get to this level, but may need help finding a company that will overhaul my stock ct26...