wy not start tuning? I think i had to take 20% fuel off the map for 550cc. I will pm my map to you.. This is for mapecu2.
pm me your e-mail. Coulnt attache via pm.
ok.
I think I will start with cps and multiplex and change later.. I need to start learning AEM. If i remove multiplex in future do i need to change some setting in AEM?
Also.. the software I have now is 1130_Stock MAF.V1.19 . In cam/cranck options option is set to supra 89-92. Is this the...
ok, could "stumble/misfire problem" be dangourus or is it just disturbing/hp reducing? So majority AEM users replace oem ignitors right away, or is it at a certain hp level these problems come up.
thanks for the tip. Se if i can stumble across one of those. Is the multiplex causing a lot of extra headace when tuning in AEM otherwise?
How many hp are you running?
I have a plug´n play AEM, but before installing I would like your AEM guys opinion. Does it work okey to use ignition-timing signal from oem cps (anything to be worried about), or should I mount a trigger-wheel.
My plan is to have a boostlevel aprox 1.3-1.4bar.
To be 100% sure the timing is ok I always check with timinglight after, and then you dont need to waste time worrying about it when you´re working. cps always comes back in some different way no matter how accurate i try (my experience).
i found the right year for my car at a nice price... so problem solved. Now its just about puting back ct26 to pass inspection and start tuning AEM after that... bah lot of work ahead.
I would not be worried about running lean. You will hit fuel cut before that happens. 2 things I would target on. Since you can hear no swooshing sound when you lift off throttle, likely you cant have any pressure in ic pipe. Either you have a leak in ic pipe (and they can be damn hard to find)...
I am not sure exactly what the oem ecu does when maf signal is manipulated, but it doesnt compensate correctley and at 1.4bar timing distroyes many 7mgte engines with piggybacks.. even with enough feul etc.
I was carefull not to go over 1.3bar and I started with rich a/f and cut more and more...
yes and you should have even less clearence problem with 18. But if I would want to lower mine more I would have to roll the fenders. I feel 18 probably is optimal for mk3.. 19 is a bit high.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.