Recent content by peteremer

Hey guys, I just rebuilt my engine, been driving it around for about a month now, and I guess I didnt seat my rear main well or my drip tank caused it to blow out, either way, I need to replace it and was wondering if anyone on here had just replaced it my removing the tranny, and if so, what's...

Well if you arnt hitting fuel cut it could be your MAF. I had this exact problem where right around boost there would be a crappy jerking and would instantly stop once i took my foot off the gas. Because your only boosting 10lbs, I would think its not fuel cut, but the problem you are describing...

Just to let you all know it was the afm! It just went bad I suppose, I cleaned mine and it still didnt work, so I put in my extra one and wala! It was fixed. No more problems and it runs like a dream...Thanks so much

What's the problem with high clamp loads?

Thats helpful...thanks guys...and yeah pierce it's almost done, just ironing out a few kinks...I'll be driving it by the end of next week. Pete

I think I have determined from looking at supra's and from other people here that this plug is only on the 91-92 7mgte model...?

That hose is a pain. The best place to get it is a toyota dealership. They have pretty cool computers that you can basicly point to the thing you need on then engine you need and they can pull it up and order it. That way you can be positive as well that it is the right bends etc. Hope this...

Tommorow I am going to check the tps and make sure its set correctly, I can also swap a spare afm I have onto it to see if that does anything I have hardpipes on order, but for now I am almost positive I dont have a boost leak, and I dont have a a/f gauge so I can't tell what thats doing.....

That could be it, I have had the car on for around that amount of time now, but I will give it a shot, and try some more "diverse driving" and see if the ECU learns a little more...

Yeah I have the lexus afm but I wanted to run the stock air/fuel setup until I got it running right.

Did you check for codes? -Yes there are no codes being given at all What all did you rebuild on the engine? -The engine was bored out .20 thousands, with all new stock internals. - .20 thousands oversized stock pistons, rings, 2.0 titan motorsports headgasket, decked block...

I just finished rebuilding my engine a couple nights ago, and when I took it out for my break in run every time I would push down on the gas it felt like it would have nothing there, as in like the engine didnt know I wanted to go anywhere and was somtimes really boggy. But if I would hardly...

So I started my car up yesterday without connecting this plug to anything, and it threw no codes and ran perfectly fine...I have no clue what this thing was ever meant to do.

Could it be that his bypass valve is stuck or broken open and he is just openly recirculating air instead of holding it in? I know that this happened to my friends which led to him getting the bosch 110.

Hey everybody, I was curious about my new clutch. I just finished my engine rebuild and took my car out of a spin and the clutch wasnt half as stiff as I thought i was going to be. By no means is it weak when pushing it down but it just feels like a stock or maybe a little stiffer clutch. I have...