timing

[san supra]

put on timing belt and can't get cps dropped right.

if t-belt is off one tooth what would happen?

i keep going between too advanced and too retarded and can't get on the right tooth.

i've been working the past hour on it.. any ideas?

 

[san supra]

i have done this many times and have had no problems


whats up?

 

[S.A. supra]

Are you gonna be there tomorrow morning? I'm going to millers and I can help you. I have stabbed them Many times, too mant times.

 

[san supra]

nope i have to work at 10am.

 

[TurboStreetCar]

Did you have the head or block surfaces machined? Are the marks lined up on the cams and the crank?

 

[NTRA08]

I just put the motor at TDC the cam gears in the right spot. And when I put the CPS in I put the notch and the drill spot right then spun the gear to the left 1 tooth and pit it in. Tharts the way I did it on both of motors and it worked for me. I put it a tooth over because when you put it in it spins to the right.

 

[san supra]

the crank and cams were all lined up perfect.

i just changed the t-belt.

i am just one tooth off but i cant seem to find the tooth in the middle of the ones im jumping between.
it starts and runs but to get to 10btdc i have to turn the cps past were i can put the bolt in.
i will try stabbing it some more later

 

[S.A. supra]

Are the cam gears on the center pin hole?

 

[san supra]

yes they are.

thread no longer needed because my t-case gaskets that i just replaced are leaking and my oil and coolant have mixed