Stripping the engine bay!!!

[87soup]

Hey guy's i have a 1JZ motor set and all my other parts for my swap comming in a couple days and i need to know what exactly to pull and keep from my 7MGE manual engine bay... Please help!!! I will post pictures soon but right now i have everything still in tact!
:1zhelp: :1zhelp: :1zhelp:

 

[jizake1jz]

i would just start going through everything and planning out what you should leave in. basically just motor and trans comes out. don't take out more than you have to now, cause it will be alot easier to wire everything up for the 1j if you know what it is.

 

[driftking786]

all i took out was stock radiator, fan...unplug all plugs...disconnect ground from back....open up passenger side glovebox and pull harness....disconnect heater hoses..unbolt driveshaft....remove shifter...unbolt tranny 4 bolts...unbolt from cat from exhaust(well thats what i did)....and remove..............i think

p.s. great time to get new downpipe,cat,cat-back:naughty:

 

[87soup]

Thanks a LOT....
I just got my intercooler, pipes, BOV pipe, BOV, air filter, oil filter... from drift motion... Thanks DM the parts are in great Shape!!!

I'm waiting on my Y-pipe, Down pipe...

I know this has been posted many, many times before but is there anyone that recently did the 1J swap that remembers all the little misc. part he/ she needed in the swap... I just want to be ready for everything,You know...
Thanks again!!!

 

[87soup]

So... Do i need to do something to the 1JZ harness to fit the MA70... I heard of some people extending it, but is that all really necessary?

:1zhelp: :1zhelp:

 

[CFSapper]

i havent done this yet but ild label every thing as your takeing it off

 

[csnow]

You can drill a hole below the speedo cable or notch the speedo hole and fit the harness in without extention. I am planning to go this route when I do my swap in a couple of weeks. Do a search on it, it is covered on another thread.

 

[jizake1jz]

oh another idea, take pictures of anything you might question later. i wish i would have taken pictures of my front clip before i pulled the motor out. but most importantly take pictures of where all the harness plugs go if you take it off and completely pull it apart like some people do. i just cut it by the ecu wire by wire and extended it.

 

[87soup]

Has anyone ran the Harness through the speedo cable???