Sheedy Built Supra

[sheedy126]

subframe completely out, oil pan all cleaned up
one of the oil squirters was opening at 4psi so i got that all replaced, shimmed the pump 5mm as well

been really crappy weather lately, hopefully itll all be done this week!

 

[CarlosPTR210]

daaammm nice work bro , no more low oil pressure

 

[sheedy126]

Started putting my morganson coils together and on the car. We will see how much better it runs this afternoon

Sent from my PC36100 using Tapatalk 2

 

[sheedy126]

New setup works great! Fired up first try and idles perfect, no more missing! Looks really clean too, can't wait to hook up the water meth injection and take it down to supra nationals in June

Sent from my PC36100 using Tapatalk 2

 

[akito]

Very nice progress man, COP setup looks really clean!

 

[1986.5supra_kid]

awesome progress

 

[supraguy@aol]

Looks great, man.

 

[sheedy126]

Finally washed and vacuumed my car. Looks much better

Also cut out the small restriction / stock bov port on the 3000 pipe

Sent from my PC36100 using Tapatalk 2

 

[CarlosPTR210]

nice nice

 

[sheedy126]

Thanks guys
I finally got a good quality (and correct one) after ordering from Napa 3 times....

A new Aisin clutch slave cylinder!
Then its ready to go down to supra nationals in June

Anybody else going to be attending that event this year?

Sent from my PC36100 using Tapatalk 2

 

[1986.5supra_kid]

Thanks guys
I finally got a good quality (and correct one) after ordering from Napa 3 times....

A new Aisin clutch slave cylinder!
Then its ready to go down to supra nationals in June

Anybody else going to be attending that event this year?

Sent from my PC36100 using Tapatalk 2

where and what days?

 

[sheedy126]

June 6,7 in Portland, Oregon

http://www.supramania.com/forums/showthread.php?190615-PacNW-Supra-Nationals-2014

Sent from my PC36100 using Tapatalk 2

 

[jdmfreak]

I plan on getting my registration as soon as I can afford it

 

[1986.5supra_kid]

SC to Oregon

uhhhh yeah it would be cheaper to fly there lol

id like to attend. If only there was another member traveling from east coast

 

[sheedy126]

Got a little bit done today.

28x10x16 slicks on stock saw blades..fit almost perfectly, could use a 8" wheel though

Sent from my PC36100 using Tapatalk 2

 

[Grandavi]

Holy crap!


'Nuff said... Sweet.

 

[IndigoMKII]

Did you flex the suspension fully to see if it'll rip a fender off?

 

[sheedy126]

not yet, i should probably do that while im test fitting

 

[CajunKenny]

Those sawblades look familiar.

 

[atmperformance]

so that's what a 10" wide drag radial looks like on a saw blade.