So i am thinking about moving my PS resevoir to inside the (US) passenger side fender and was wondering if i did that would i still need the PS cooling hard lines? My thinking is that by moving the PS resevoir to someplace outside the engine bay it will act as a cooler of it's own. However, it will not be getting direct air flow as it will be between the fender, fender liner/protecter, and firewall so i wasnt sure.
My next question is do IC hard pipes need to be bead rolled at the end? This is i am sure a dumb question but i need to cut my lower IC pipe (turbo to IC) and can't find anyone in this area who can bead roll it for me. I bought the CX Racing IC pipes but have a modified turbo and an aftermarket IC and with the pipes connected the IC pipe goes about 3/4 of an inch inside of the IC piping. If i do need it what would be my best bet, making 2 cuts, removing the middle, and then welding the end with the bead roll back on? I am thinking i might be ok without it because the IC doesn't have bead rolled or flared ends but just don't know.
My next question is do IC hard pipes need to be bead rolled at the end? This is i am sure a dumb question but i need to cut my lower IC pipe (turbo to IC) and can't find anyone in this area who can bead roll it for me. I bought the CX Racing IC pipes but have a modified turbo and an aftermarket IC and with the pipes connected the IC pipe goes about 3/4 of an inch inside of the IC piping. If i do need it what would be my best bet, making 2 cuts, removing the middle, and then welding the end with the bead roll back on? I am thinking i might be ok without it because the IC doesn't have bead rolled or flared ends but just don't know.