Oil filter sandwich adapters *pic*

[92nsx]

I see These Oil filter sandwich adapters for the mkIV. It goes between the oil filter and the block. Will they wrk on our 7m? I like it, no need to drill and tap hole for oil temp sending unit, or any other oil sensor, cooler thing i can think of. here is a pic. If the MKIV dosent fit any one know our thread on the oil filter? I think they have many sizes.

 

[Jeff Lange]

JZ and M use same filters, can't see it not fitting.

 

[92nsx]

JZ and M use same filters, can't see it not fitting.

Sweet and i think you would know best :bowdown: :bowdown: :bowdown: :bowdown:

You think any clearance issues we would have adding this 1" to filter or the sending units hitting anything?

 

[Jaguar_5]

thread is 3/4 - 16

What are you trying to do with this? If it'll fit depends entirely on what you're trying to accomplish

 

[92nsx]

thread is 3/4 - 16

What are you trying to do with this? If it'll fit depends entirely on what you're trying to accomplish

Add oil temp sensor with out drilling.

 

[Jaguar_5]

Not the route I would choose to take but it should work fine

7MGTE or GE? Might have problems with the GE, but the GTE has a filter housing that points the filter down 90* so it should be alright, but it'll probably be bring it really close to the exhaust manifold..

I would just do a oil filter relocation, and add the sensors there (and while you're at it might as well go full flow thermostatic oil cooler setup ) Or you can get an adaptor and Tee for the stock oil pressure sensor, and add the aftermarket one there, that's probably your best bet

 

[92nsx]

Add tee that also would work since the 7mgte is out of the car any ways. o ya it a turbo the only way to go.:evil2: