maft pro intake temp sensor location

[Justin]

is there any issues with putting the air temp sensor too close to the BOV? its setup for FFI, and I was wanting to put it about 1.5-2 inches from the bov...

could that cause any issues or am I good to go?

 

[pimptrizkit]

set up for a forward facing intake?

then make sure it's close to the throttle body,

i have had mine above the valve covers in the 3k pipe also in the intake pipe before the turbo, and dislike both locations,

 

[Justin]

the BOV is very close to the TB as well...

 

[DaemoN]

Mounting it after the BOV and before the FFIM would be fine, iirc the point is to sense the temperature of the air going into the motor so it can calculate density properly

 

[GrimJack]

No problem, just keep it away from heat sources.