loom running to electronic distributor

[24vtoy]

hey guys

i messed up my car, please help me

its a 7mgte motor with oem coilpacks

the plug that runs to distributor was breaking off a bit, i wasnt in a good mood so i snapped the whole plug out, then realising the wires from the loom and the wires from the distributor has different colours,

I dont know what i’ve done

This is the colour breakdown

From loom

Black
Red
Yellow
Blue

From distributor

Yellow
Yellow
Green
Red

Ive tried matching them either way but car still wont start, which is the right way these wires should go on

the pic attached is to show, wiring on the left is from the loom, wiring on right if from distributor

 

[gats]

Try these:

http://www.supramania.com/forums/showthread.php?35540-JDM-CPS-wiring&highlight=CPS*+wiring

http://www.supramania.com/forums/showthread.php?48404-CPS-wiring&highlight=CPS*+wiring

 

[radiod]

While you're at it...

You can get the connector and 4 pins with large seals for the loom side, as well as a replacement CPS connector and you'll be good to go I had to just do all of this recently too, they get warm sitting right over the exhaust manifold and the plastic/wiring gets pretty brittle from the high heat. It's especially bad if heat shields aren't in place over the manifold and turbo.