intercooler pipe, gauging interest hope its ok.

[tomjan87]

If this is anyway not allowed, than feel free to take it down and let me know. thanks,

anyways, on to the piping.

I started to build intercooler piping today for my supra. i was thinking of making a base model, and making more to sell. Would anyone be interested it that.

I can make either piping that goes through the original path, or that goes through the old intake hole.

pipe can be 2-2.5 inch in diameter.

it is hardpipe(metal) welded at the joints, clean/strong welds.

it is not polished or coated, buyer can do that on his own.

Still not sure on the price, and I hope to have pics up soon. I am about halfway done with the base set for my car, and hope to have it done tomorrow morning sometime.

thanks for looking and let me know what you think.

Joe

 

[Insidious Surmiser]

i'd buy em for stock location...

 

[koulee]

i'd buy em for stock location...

Depends on how much it would cost. If I can get them made for cheaper by a local muffler shop ...

 

[tomjan87]

imstill checking how long it takes me, and if you get them at a muffler shop, it wont be mandrel bent, i dont know of many shops that have one, but if yours does, more power to you.

Joe

 

[tomjan87]

I forgot to say above that the bends are mandrel.

Joe

 

[Insidious Surmiser]

any idea on the cost?

 

[Reign_Maker]

Moving to general... Good luck with your interest...

 

[JB91389]

I'd buy it for stock location, depending on price

 

[johnathan1]

I'd buy it for stock location, depending on price

Me too.

 

[pimptrizkit]

eh,

i went through a muffler shop, never doing it again!

i brought him my own mandrel bends, and paid him to peace i to gether fit and weld...


pm me a price range....

edit~ talking about pipes like these..

you going for an upper and lower pipe or are you going to break them down into 3-4 sections?

 

[Shytheed Dumas]

Stock location dependent on price for me, too.

 

[suprahero]

Joe, would they come in sections where we could just connect them with couplings? Maybe build them in three sections like Pimp suggested or asked. I've been contemplating doing my own, but I don't have access to a mandrel bend. I'd have to have it done at a muffler shop. Post pics asap, and a price.................lol