Been doing some more boost leak testing, blocking off different areas and testing different sections. Did it with between the compressor housing and before the throttle boddy with the BPV on and noticed that the BPV was not holding a lot of PSI. Maybe > 2-3psi. I can't blow through it but when it starts to build pressure it starts to let are by slowly, then starts to flutter and fart air through.
So i'm guessing thats my issue. Going to get a Bosch BPV. But was wondering how bad it would be to run without a BPV to test and make sure thats my problem.
edit: I'm running about 7-8psi with Apexi Intake. Everything else is stock.
So i'm guessing thats my issue. Going to get a Bosch BPV. But was wondering how bad it would be to run without a BPV to test and make sure thats my problem.
edit: I'm running about 7-8psi with Apexi Intake. Everything else is stock.