found this!

[doom26464]

dunno if this is a repost our not but:
http://cgi.ebay.ca/Alu-Throttle-Bod...ryZ33742QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

seems like a pretty good pipe to replace the whole upper pipe and if they offer bov flange even better. For 100 buxs that farly cheap in my books

just noticed T-clamps too thats a bonus!

 

[EvoLuTioN]

it'll be a good and cheap upgrade

but.. no 7M here no care

 

[blackturbona]

would be better if it was one peice

 

[Rennat]

You could easily get that welded together... lol.

And to me that seems like a pretty good deal for $100. Granted you MIGHT be able to make it a little cheaper... but the ends are beaded...

 

[themadhatter]

be nice if they had a port for the stock bov. So lets recap some speedsource makes the lower charge pipes(turbo to intercooler) this guy makes the upper charge pipe(throttle to fender) so when is some one going to come out with a replacement fender to intercooler pipe lol

 

[TheRemedy]

i actually ordered this the other day...and a 2.5inch BOV pipe..im gonna lay them out and get them welded up as one peice and hopefully grind them smooth

 

[supraman7mgte]

Anything to replace the stock sytem...
Good deal

 

[Poodles]

one piece would be an EXTREME hassle to remove when you need to do any service...

Not to mention it has tabs to screw the extra pipes down, but no tabs to actually screw the piping itself to the engine. Too much flex would be allowed IMHO...

 

[blackturbona]

one peices arnt that bad to remove, i have one and its only kinda annoying to wiggle it free while running into other things, by no means an extreme hassle

 

[ViR2]

I would rather see lower pipes...

 

[GrimJack]

I have a one piece, and mine is a PITA to remove. However, mine goes from the throttle body all the way through the headlight hole - the first coupler isn't until well below the headlight.

It's an even bigger PITA to get back on!

I've seriously considered getting it cut in the middle and adding another coupler.