Exhaust setup thread.

[Ma70.Ent]

Post up your exhaust setup! Specs and pics of course. Some examples of some specs to post up are brand name, diameter, what muffler(s) you're using, what resonator(s) you're using, how loud it is (in your opinion), and other comments.

I'll start.

Custom Exhaust
2.25 inch outer diameter
Two 14 inch oval magnaflow mufflers
No resonators (since I'm using mufflers)
VERY quiet. Good to cruise with.
Performs way better than stock exhaust, but I'm not sure how it would be on other cars. I'm currently running the stock exhaust manifold though.

 

[cuel]

OBX header, test pipe, 2.5" piping, Magnaflow 24" glasspack in stock resonator location, 2 chamber FlowMaster out back. Deep, and quiet at idle, screams at WOT, with a real nice tone. No droning in any rpm range, and just loud enough to hear at cruising speeds.

 

[HommerSimpson]

3 inch into 2 x 3 inch

 

[BorHor]

2.5" to 2 2.5" mufflers. Will make it 3" to 2 2.5" when I make power though. I'll add pic to this post when I get time but my sig shows what it looks like.

 

[CyFi6]

2.5" custom from cat back
Vibrant muffler
Too loud in my opinion, needs a resonator. Some annoying drone at lower rpms

 

[Fuzz420]

2 1/2 straight pipe, cat, and no muffler

I actually preferred this setup over my "autozone muffler" i had.I actually gained 9lbs/tq and the car felt stronger everywhere. Only downside was the noise. Wasnt too bad on the highway, sounded almost exactly like the car did with the muffler, but WOT and taking off from stops was a totally different story

Sorry no pics, but heres my last dyno vid:

http://youtube.com/watch?v=dnPGSypi9Zk
and you can see during the first run i covered my ears up. I was easily the loudest car at a few shows

I made ridiculous tq too(215ft/lb), then a few days later the hg blew

 

[cartech08]

stock manifold-three ft. of 2 1/4, step up to 3" all the way out the rear. Nice low tone at idle, way too loud and crackles at around three grand to redline. Plan on dropping back down to 2 1/2 with Top Speed muffler.

 

[labrat469]

Mine has a stock exhaust manifold, 2.5 inch piping, no cat and a Dynomax Super Turbo muffler

 

[Nalleywhacker]

pacesetter headers and a cat thats it, and i love it!

 

[gofastgeorge]

Pacesetter headers,
Custom collector in place of POS one that came with them,
Pre-muffler in place of cat,
Stainless JDM 80mm all the way to the shorty 6" dia muffler.

Deep rumble at low RPM,
Banshee wail from 5000 to 8500.

I try to look unconcerned when I pull up to a cop at a stop light.:naughty:

 

[Nalleywhacker]

Pacesetter headers,
Custom collector in place of POS one that came with them,
Pre-muffler in place of cat,
Stainless JDM 80mm all the way to the shorty 6" dia muffler.

Deep rumble at low RPM,
Banshee wail from 5000 to 8500.

I try to look unconcerned when I pull up to a cop at a stop light.:naughty:

damn! 8500!!! what you got done to your head?

 

[sean210]

Stock manifold
No cat
2.5'' Magnaflow

That gave me
198rwtq

 

[Ma70.Ent]

damn! 8500!!! what you got done to your head?

It's a built head. I think he's posted a link to what he's done to his car on many occasions.

 

[ALEXMKIII'86]

Custom exhaust
OBX header (heat wraped)
OBX downpipe (heat wraped)
high flow cat from summit
cat back 2.5'' exhaust pipe
and a focus muffler
pics coming soon...

 

[MA70 Ed]

stock headers
no cat
2.25 crush bent piping w/resonator
magnaflow muffler
sounds real good, and spits fire!