Driveshaft?

[Ric]

I have this driveshaft with a 21 tooth input shaft. Any idea what that is for? W58 or R154 or V160?

 

[SLO-MK3]

I'm pretty sure thats for the W58. I got one out in the garage that I can't seem to get rid of. I'll go out and count the splines in while and get back to you if its different.

 

[Ric]

I was told it might be for a 5spd SC300.. Some googling said W58 is 21t

 

[IJ.]

154/a340 is 23 spline 40mm diameter.

 

[Supracentral]

I have this driveshaft with a 21 tooth input shaft. Any idea what that is for? W58 or R154 or V160?

What's the length? It might be a MKIV N/A 5-speed shaft.

 

[Ric]

I still didnt get the lenght. Seems kinda long for an SC300 shaft. If you have a W58 tranny with a bad carrier bearing or front u-joint, you can still use this no matter what car you have. The front shaft is the same lenght on every car (so i've been told). A new front shaft from toyota is $600+(ujoint is not replaceable), and a carrier bearing is $120. Any driveshaft shop can press it apart for less then $30. If your bored, you can beat it off and back on with a hammer.

 

[Ckanderson]

just wondering... how'd you get a driveshaft that you dont know what it's for?