My '88 came with ABS stock. The previous owner had the current 1JZ/JDM r-154 swapped in, from a non-abs supra.
Initially I thought I was simply missing the rear abs speed sensor, mounted on the extension housing/output housing of the trans. (the body connector is in place; antilock code stored is for rear speed sensor). But when I got under the car to change the fluid and attempt to install the sensor, there is a small plug where the sensor would go. The plug is similar to a freeze plug, but it is much smaller (about .5" wide).
Dealership shows two different part numbers for the abs/non-abs extension housings, and I can't determine if they are actually different, or if there is just a plug in the hole on the non-abs models. There IS a threaded hole next to the plugged hole, for the sensor to mount to.
So, has anyone ran into this situation?
Is there an easy way to remove such a plug (without removing the housing completely)?
Can anyone confirm the difference (or lack of) between the abs and non-abs r-154 rear extension housings??
Thanks in advance.
Initially I thought I was simply missing the rear abs speed sensor, mounted on the extension housing/output housing of the trans. (the body connector is in place; antilock code stored is for rear speed sensor). But when I got under the car to change the fluid and attempt to install the sensor, there is a small plug where the sensor would go. The plug is similar to a freeze plug, but it is much smaller (about .5" wide).
Dealership shows two different part numbers for the abs/non-abs extension housings, and I can't determine if they are actually different, or if there is just a plug in the hole on the non-abs models. There IS a threaded hole next to the plugged hole, for the sensor to mount to.
So, has anyone ran into this situation?
Is there an easy way to remove such a plug (without removing the housing completely)?
Can anyone confirm the difference (or lack of) between the abs and non-abs r-154 rear extension housings??
Thanks in advance.