hey everyone. as i rebuild my harness and double check everything I wanted to try and clean up as much wiring as possible, and allow for easier installation and removal of the intake manifold.
Have any of you fellas changed your harness routing to accommodate this mission? If so where did you run the large group of wires that usually sits on the fuel rail? any pictures or tips on how to remove some of the wiring mess under the hood?
Have any of you fellas changed your harness routing to accommodate this mission? If so where did you run the large group of wires that usually sits on the fuel rail? any pictures or tips on how to remove some of the wiring mess under the hood?