Anyone run Master Power turbos?

[lowtaco]

Just found out about these from a friend, was wondering if anyone has used one or have any good info on them?

T3/T4 Super 60

Compressor Wheel Compressor Housing
Inducer dia. Exducer dia. Trim A/R Air Inlet
58.1mm 84.0mm 48 .70 76.
Turbine Wheel Turbine Housing
Exducer dia. Inducer dia. Trim A/R Div/Undiv. Discharge Inlet Part Number
56.0mm 61.5mm 83 .63 Undivided 4 Bolt T3 940005-1156

 

[wiseco7mgt]

Never heard of them, i believe they are a myth and you needn't waste your time searching for them anymore.
http://www.supramania.com/forums/showthread.php?t=94614

 

[lowtaco]

Never heard of them, i believe they are a myth and you needn't waste your time searching for them anymore.
http://www.supramania.com/forums/showthread.php?t=94614

Thanks!

 

[92nsx]

There are quite a few members here running them here. Plus tons of dyno sheets posted with there turbos on a 7m

 

[lowtaco]

Ive also seen the T70's with the .68 hot side, you think this would be too agressive of a turbo on a stock rebuild with fuel upgrades?

 

[Neodeuccio]

My buddy is running a masterpower GT45 (I think) on his 355 ci LT1 race engine. The thing is sick!

 

[TurboStreetCar]

T70 here. no tune or full boost yet though. There good stuff. Perfect for a turbo on a budget.