AEM wideband 02 sensor used to feed ECU?

[Sam]

I have an issue. I went with the driftmotion single turbo kit, but now the stock 02 sensor doesn't fit in the screw-in bungs. I do have an AEM wideband 02 sensor and gauge however. Aaron at Driftmotion said it's possible to use the AEM's wideband 02 sensor's narrowband feed to feed the ECU. It's as easy as slicing the proper wires to feed the ECU.

However, I have no idea what any of the wires do on the stock 02 sensor or the AEM 02 sensor, so I can't wire it up.

Has anyone ever done this? I took some pictures of the wires in question.

This is the plug coming off of the AEM widband 02 sensor. There are five wires; red, green, white, silver, black.

These are the wires coming off of the stock 02 sensor.

Plug for the stock 02 sensor. Two black wires are the top connectors, blue it the bottom.

 

[thesupragod]

i also have an aem uego wideband... however it does not have a narrowband output.... so the ecu would see it as an unuseable signal.

 

[Sam]

Ah. Thanks for the answer. I'll just chop a hole in the exhaust, extend the stock 02 sensor's wires, and weld that bastard in place. Problem solved.

 

[whitemike]

I've been reading that the UEGO does have a narrowband analog output 0-1v but I can't find any documentation on it. Do you have the manual? Can you find anything about a 0-1v output?

 

[Sam]

Found this.

It sounds like I don't have the proper kit to run the dual feed from the AEM wideband. Unless I just don't understand what's going on, which is quite likely.

 

[whitemike]

Well do you have that controller, or just the sensor/gauge ?

 

[Sam]

Just the 02 sensor and the gauge is what I have.