1JZ won't crank after clutch master replacement

[xXslayrXx]

I couldn't find a sticky thread or any other thread related to my problem so I'm posting this and hopefully this will help some other 1J owners down the road. So I swapped my clutch master cylinder yesterday but now the motor won't turn over. No Check engine light, no blown fuses, etc. Not really sure what to do. I know the battery isn't dead because I tried jumping it. Any help is greatly appreciated.

 

[IJ.]

Clutch switch?

 

[xXslayrXx]

Clutch switch?

There was only one wire that I disconnected when swapping the master cylinder and I reattached it like it was before. I'm guess that's the clutch switch, it's under the column by the pedal right?

 

[IJ.]

Yep make sure the switch isn't jammed in.

 

[xXslayrXx]

Yep make sure the switch isn't jammed in.

Nope. It's fine. I'm really at a loss at this point. I've completely run out of ideas. :1zhelp:

 

[IJ.]

Unplug it and try.

 

[xXslayrXx]

Actually found out that one of the wires to the clutch sensor was severed, fixed that and runs just like before. w00t!

 

[IJ.]

Actually found out that one of the wires to the clutch sensor was severed, fixed that and runs just like before. w00t!

LOL thought you said the switch was working fine

 

[Boostedmkiii]

lol the switch was fine. Just bad wiring!:biglaugh: