Hey guys,
My car seems to be idling very rich, around 11.7 and the car generally only will cruise at 12 or under AFR.
The problem is when I hit boost it likes to get around 13 which I know isn't that good for the engine.
I am running a .57 for now (about to install a 60-1), Lexus afm, 550s...
Hi guys,
I am looking at boomslang to make me a jumper harness essentially for a SAFC 1 for my ecu. I don't feel confident splicing my already hacked up harness (thanks to previous owner). So it would plug into my ecu and be a direct wire up to a SAFC unit.
I've never used the actual SAFC but I...
So I am not running a afpr.
Finally got my wideband hooked up. Idle at cold start is rich around 11. But once I get going it settles down to 14. At normal non boosting highway cruising my afr is good, around 14.5
At boost around 10psi my afr is up around 13-14.
Shouldn't it be like 10-11 aka...
So to start my car has the following:
-57 trim
-550cc injectors, Walbro with 12v, and Lexus afm
-Intake and exhaust and intercooler all 3 inch
-Apexi muffler
-Profec B push in dial boost controller
Before I did my 550/Lexus upgrade I purchased a fcon with a Fcd and gcc. My car when I bought it...
Hell of a night tonight. Just had 550's installed and Lexus from a local garage. Went for a boost and it doesn't like anything over 10psi. Engine light comes on... I did the upgrade because my f con did nothing for upping boost. Anyways, on my way home I had smoke everywhere after a few pulls...
Ok. I just hope this f con is working properly. Is it not supposed to give you 15psi? And I am talking about the harness that connects my Ecu to the f con.
Hey guys,
So to start I bought my car with an old style Profec B 1 with push in dials. The original owner had the mild and sharp set in the middle, and low boost set around 12psi. He had the hi boost set at 0?? Dunno why.
I purchased a f con with a gcc and all appropriate harnesses.
The...
Hey guys,
Been researching lots but was wondering what was the best way to tune my 7m with a Fcon and gcc.
I have a FJO old school Wideband and a E105v chip in the f con with a gcc harness.
I've read that you start with the 1-9 wheel inside the f con and then fine adjust with the gcc? Is...
Loving the thread. Just installed my f con and waiting for my GCC to arrive. I don't know how the heck you are suppose to bend those wires and jam that ecu up there? That sucker is tight in the glovebox! Lol
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.