But I can pull the one shift lever back forward and spin the transmission freely so that would mean it's not stuck right? It's just every time I put it back together that lever pops back forward and sticks it in gear and I can't get it out.
Ok, so I was helping a buddy do an auto to manual swap in his car and everything is done. During the process I had to remove the rear housing to install his shift selector because the transmission he got didn't have one in it. After finishing the job and firing the car up (thank god on jack...
Just did another check and found my injectors are not firing. They don't make any noise while cranking. Pulled a plug no fuel making it into cylinder. When I ark the wore from b+ to fp the pump whines. Replaced the injector resistor with a known good one off a running car still nothing ?
Ok so i have an 87 7mgte basically stock except for an after market bov. It was running great and my fuel gauge doesnt work so in process of trying to fix it i pulled my gauge cluster out and changed the fuel gauge out with a 90 7mgte fuel gauge. i also changed the tach and temp gauge too...
Nah didnt use the relay set up. I got new headlight pigtails, grounded one and ran a wire to the other side and hooked them to the switch. Then I pulled the circuit board off my tail lights on the passenger side and tapped into the wire that powers the parking lights. Only have to run that...
Found a universal headlight switch at autozone with a fuse in it. Ran a wire to the tail lights and one to each headlight powered from the battery. Only cost me $10 with wire.
Year of car: 1987
Name: James Winkels
Contact info: 9313381703 suprchipmunk@yahoo.com
City: clarksville
Hobbies: obviously cars
Uprgrades:nothing really, knock off greddy bov. Car had been sitting for 8 years when I found it and saved it. Just got it running.
Before the switch went put I had to joggle the switch to get the lights to come on sometimes. They would flicker sometimes and if I messed with the switch they would stop.
I've searched all over and cant find it anywhere. My headlight switch went out, and i dont really currently have the money to buy a new one. Kinda in a crunch and was hoping someone might have an idea of how to wire it to a toggle switch. I pulled my lower dash and around the steering column...
It runs great now but now I have another problem. The fuel damper leaks out of the top. Replaced the washers still leaks. I put a good damper on and still leaks out of the top, not by the threads but on top like where the lip is under the plastic cap. I read somewhere that you could replace it...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.