Thanks guys for all the responses. The problem occurred after my rebuild.
I will rebuild the transmission replacing seals synchros and bearings.
Hopefully this solves the problem.
some fabric from a textile shop.
I believe its an internal issue with my tranny. Nothing was wrong clutch wise, lines, pedal or anything else.
Im planning on rebuilding the r154.
I believe its an internal issue with my tranny. Nothing was wrong clutch wise, lines, pedal or anything else.
Im planning on rebuilding the r154.
Thanks everyone for the help.
The flywheel is stepped, flywheel, clutch and all other parts were working fine before i rebuilt the motor.
The flywheel is stock and has been machined about 3000 miles ago.
I did not bench bleed the master, so i will bleeding the master by opening the hose as Typhoon suggested.
The clutch fork...
There are no leaks in the hydraulics system from what i can tell.
The pedal is extremely stiff, i bleed over a bottle in a half to make sure that all the air is out.
I also adjust the pedal out a tad bit to make sure the fork is moving to its true potential.
Yet the car will not go in gear...
appreciate the reponses
I pulled the tranny to make sure the clutch disk was not backwards.
It is not even possible to bolt the pressure plate down with the clutch disk backwards.
I will try bleeding it some more since i did not bench bleed the clutch master
the clutch fork is moving
the hub is...
Thanks for the responses
I pulled the clutch off every 4 times I checked it.
It's not even possible to put the act stage 2 clutch in backwards since the springs raise too high to allow a backwards install lol
I can see the fork pulling the hub to move the throwout bearing
slave and master are new
I did not bench bleed it. However i did bleed it on the car about 20 times with no more air coming out.
I will try bleeding it some more.
thanks
---------- Post added at 08:59 PM ---------- Previous post...
Any info appreciated
I just finished a motor rebuild and my clutch won't disengage
I can shift into gear with the motor off, but when on, it wont go in gear.
R154 transmission
Act stage 2 clutch
New Slave and Clutch Master cylinder
New pilot bearing and throwout bearing and hub all the...
Any info appreciated
I just finished a motor rebuild and my clutch won't disengage
I can shift into gear with the motor off, but when on, it wont go in gear.
R154 transmission
Act stage 2 clutch
New Slave and Clutch Master cylinder
New pilot bearing and throwout bearing and hub all the...
aight jeddy sometime this week
I am relocating the coilpack and setting up the throttle cable directly to the tb
since I cant source 2 gte injector plugs
I appreciate the love for the interior.
the only thing holding me up are two gte fuel injector pigtails.
I'll get some decent shots of the interior this week:D
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.