Search results

So I went through every thing the gauge it self works, the sender works, and the wires have continuity. But when I go from (h1)3-4 with a test light nothing, when I disconnect the h1 plug the gauge doesn't move. I think it's a ground some where? Any ideas?

The lower control arm bolts are suppose to be flat I just bought a new set and there flat , the upper control arm I think is flat to but mine have a curve to them.

I have a 89 with a 1jz and the fuel gauge not working and can't find a replacement level unit. Anyone know the resistance in the unit so I can see if its bad?

Figured out what it was , the wheel chafed some of the wires from the fuse panel under the hood all fixed now

Could be I but its a new key/tumbler ill check the part behind it

So I've been driving my supra for a month now all was fine until the other day, I turned the car off and it stayed on. The engine turned off but the radio dash warning lights and ac/ heater stay on. But I unplugged the am2 fuse plugged it back in and was fine, now it's the second time and I...

That's what I'm thinking

I'm having trouble adjusting my apexi avcr, its installed correctly as the manual. It doesn't crontrol the boost at all no matter what I adjust. I did a single turbo swap with an internal wg set a 13 psi and its a t28 size turbo, any ideas?

It's mechanical and I tried both no luck

I have a set of oil drains and feed if you want them and I have a set of mint turbos too

So I single turbo my 1j and I have a auto meter boos gauge and I can't seem to get it working properly. I can either get it to read vacuum or boost but not both at the same Time. I've hooked it into the manifold by itself, and I've hooked it into throttle body by the power steering pump. Can't...

Yes i fixed it blocked the iac runs like a champ 1st to 2nd burnouts :)

Booster has been painted recently no rust no boost leak test mods are fmic oil catch can apexi boost controller cheap greddy bov

Mine with it in cold start 1500 then will drop to 900 but still will stick at 1100 to 1500

Is this it i dont think it is

So i think i found my issue the iac rubber seal was missing i think i found it anyone got a pic

So i checked the codes and nothing so im thinking vacuum leak? Heres another vid https://www.youtube.com/watch?v=wQCEyuJEmIw&feature=youtube_gdata_player

Thanks didn't come up

Cant find 1jz codes helo plz

So i havent checked for codes yet been busy had enough time to plug the vacuum line to the brake boostet and it still did the same thing im checking the codes tomorrow