Search results

http://www.cygnusx1.net/Supra/Library/TSRM/MK3/manual.aspx?Section=EC&P=12 edit: wrong link.

usually i put the pressure plate on the r154 first so its easier to get the c clip on. did you loosen the engine mounts and tilt the engine back a tad? can you take pictures?

usually they do or can look them up. but majority of the mechanics out there are lazy and want to get to the next job, so an impact blast does the job for them.

mk4 brakes are bigger and duel pod. great upgrade for the rears with the front bbk.

:3d_frown:

removal http://www.cygnusx1.net/Supra/Library/TSRM/MK3/manual.aspx?S=EM&P=39 instillation http://www.cygnusx1.net/Supra/Library/TSRM/MK3/manual.aspx?S=EM&P=55

nice job. how did you do that fuse box?

http://www.supramania.com/forums/showthread.php?99651-7M-stroker-build/page8&highlight=7mgte+stroker post 149. you end up having to shave the oil pump drive shaft so it doesnt hit the rod and his ended up snapping. IJ didn't you have to do this on your 7m also because of the high rpms?

saw that the first time but over looked it the other times my bad.

http://www.cygnusx1.net/Supra/Library/TSRM/MK3/manual.aspx?S=FA&P=20 its supposed to be 106ftlbs. so its not going to go anywhere.

^ ive been in that situation where i could not see the road because the other persons light was soo bright. either the guy had 10k+ lights or they were just really scattered but even after i passed him my vision was still messed up.

man i was disappointed on this thread, i saw the video on how toyota made the 2jz block but that was the only assembly video i ever saw..

wait what? im hearing that you can use both high and low impedance injectors on the same system with ill effects?

did the rear timing cover have a lip over the block?

as far as i know no. what are you worried about? i just did springs an shocks and i dont remember seeing a washer there.

.54 is kinda small. what kind of car was this off and what Ltr engine?

you learn from your mistakes.

lol. duct tape nor jb weld should never be used other than a temp solution to get you home.

jb weld seriously?

stock repair manual say 58 ft lbs which should be about 72 ft lbs. but if your buying the cheapest hg and torquing to 58 its not going to last long.